Interior/Audio/Electrical/Wiring
7,599
Total Topics
25
Showing
4
Page 4 of 304
Topics in Interior/Audio/Electrical/Wiring •
newest topics first
Hi, basically the old Toyota key broke apart, I did leave the actual FOB bit with the buttons in what I thought to be a safe place but now its done a ...
is there any options to socket a 5sfe OBD 1 computer or should i just build a DIYPNP any other reccomendations would also be great thanks in advance...
Alright, got a chance to sit down and get my info together. My setup is an IS300 wheel with the E-shift buttons, IS300 clock spring, PAC Audio SWI-RC ...
Hello from Maine,
I don't know where to buy "a12v5w" replacement bulbs.
These are for the dome lights in a 1995 Celica GT convertible.
Can I get a clu...
im not sure if it is technically illegal but i haven't done it to my actual car anyway that was just a cluster out of my parts car and im not saying f...
Before i start anything...
WARNING, I DO NOT, REPEAT, I DO NOT affirm, state, and or indicate or any other similar word, that this is the most absolut...
[quote name='The_enD' date='Aug 11, 2017 - 1:02 PM' post='1092422']
wtf, Stefan, I told you how it is on Facebook ...
[/quote
Teo mate it's all sorted...
Hello,
I recently got the JDM tail lights that came with the japanese wiring harness.
Should I use the JDM wiring harness or use the original (USDM) w...
Can you post a photo of the light that's flashing? It may have a non factory alarm on it that's setting off and disabling the starter....
I went to lock my doors today and the pass. door refused to lock. I would physically move the lock tab, but I could tell there was resistance somewher...
hi guys i have a problem with an Sensor ground signal.
I have a st202 with an St205 jdm engine, after swap i try to connect IC water pump according wi...
Hey there 6GC, I've been lurking around here since I got my beautiful Celica; she's a bit rough around the edges and I'm doing all the work on her mys...
Is there any difference in the wiring harness for a 3 speaker per door panel, and a 2 speaker per door panel?...
hey guys so the other day i went to pop the rear hatch on my 96 and the lever just felt as if the trunk was already popped and it was the same thing f...
Hey I got a question, my high beams have never worked since I bought the celica when I push the lever forward to turn them on the high beam light doe...
^This.
Get a plug from a Tundra harness and wire it into the OEM Celica harness. You'll need both wiring pin-outs, but it shouldn't be that hard. It's...
Go buy some aluminum stock, some rivets, and make anything you want. c:...
Can close this topic. I purchased the one sandusky had and found out the info on them i was looking for....
So how do i go about removing the wiring loom from engine bay? This is what it currently looks like. Its going to be painted and need engine bay clear...
Check under the seat if there's a module. If it does, you just need the remote then....
Check for corroded sockets and terminals, may need to split the fuse block to look inside for problems....
My project for the day was installing indiglo gauges on a GT. The process for ST and GT4 should be the same. This is my first write up so bear with me...
I bought my first celica about a week ago and it came with some ugly generic aft we market fog lights that were broken anyways so i went to take them ...
no, in the alarm relay. likely under the dash.
Will look kind of like that. Paper clip won't work, needs to be heavier wire with spade terminals so it...
Does anyone know if you buy the universal seat brackets made for the 7th gens will they be the same bolt on as the 6th gens bracket bolt holes because...