stephen_lee's Posts - 6GC Forum Archive

📝 stephen_lee's Posts

stephen_lee

📍 Houston, TX

Member

Posts

2,814

Vehicles

🚗 View Vehicles

2000rpm when starting:-( - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

the ecu will idle high when its COLD out. near freezing, to help the engine warm up and keep a steady idle.
I think you're normal there.. the revs should go down to 1200 or less when the temp needle m...

Topic ID: 81347 • Post ID: 9643390

cams for 7afea - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

send them out to be reground

Topic ID: 81343 • Post ID: 9643375

what i need to go 350hp - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › General Discussion

boom

Topic ID: 81341 • Post ID: 9643339

RPM @ idle - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

that valve is a "normally closed" type valve. its stuck open obv lol. you can try to save it by spraying throttle body cleaner into it.
as far as i know, AC is the only thing the ecu uses it for.

Topic ID: 81334 • Post ID: 9643241

RPM @ idle - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

vac lines that run on the rear of the 7A are:
ac idle up (to the solenoid that has 2 vac lines and a 2 wire connector)
and power steering idle up, also 2 lines, runs under the manifold, a little large...

Topic ID: 81334 • Post ID: 9643238

RPM @ idle - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

i would replace all the hoses if a few are in bad condition, as they all have been exposed to similar conditions. take a piece into the parts store & ask for that same size

Topic ID: 81334 • Post ID: 9643233

RPM @ idle - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

You find the cause?

Topic ID: 81334 • Post ID: 9643225

RPM @ idle - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

big vac leak will make it do that.

Topic ID: 81334 • Post ID: 9643223

5fse rough rmp at cold start up - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

Coolant temperature sensor. Replace it.
It's the 2 wire sensor on the coolant neck near the dizzy.

Topic ID: 81333 • Post ID: 9643220

Need new belt(s) - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Engine/Transmission/Maintenance

theres the:
ac belt
water pump & alt belt
& the power steering belt (runs off the water pump pulley)

Topic ID: 81324 • Post ID: 9643118

De-Badging - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Exterior Styling

I agree with Daniel. The car looks good with only the "T" emblem.

Topic ID: 81315 • Post ID: 9643029

Couldn't get Wheel Alignment because of Modifications? - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

6th Generation Celica › Suspension/Handling/Braking

MIDAS tried this with me. said i needed crash bolts. he wanted to adjust my camber to +0.5 degrees. i told him hes crazy & pulled up the Toyota recommended camber settings and told him try again

Topic ID: 81303 • Post ID: 9642915

My mr2 v6 swap - 6G Celicas Forums

EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)

Other › Off Topic

QUOTE (P5ycho @ Nov 1, 2011 - 4:03 PM)
QUOTE (kurt95gt @ Nov 1, 2011 - 8:59 PM)
How does the 3vzcar feel power wise
only driven round the industrial estate at the moment, not had a proper chance to dr...

Topic ID: 81300 • Post ID: 9642885