📝 Culpable04's Posts
purplegt4's 3SGTE Swap - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Forced Induction
check slave as jeff said, if that checks out, inspect the master cylinder and bleed the system again, it may be something as simple as air in the system.
Topic ID: 77065 • Post ID: 9540741
purplegt4's 3SGTE Swap - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Forced Induction
could have gotten the tensioner already, and I'm sure for cheaper.
good luck with the project.
QUOTE (Culpable04 @ Oct 30, 2010 - 4:26 PM)
this is from his post
QUOTE
- Idler and tensioner pulleys (sa...
good luck with the project.
QUOTE (Culpable04 @ Oct 30, 2010 - 4:26 PM)
this is from his post
QUOTE
- Idler and tensioner pulleys (sa...
Topic ID: 77065 • Post ID: 9540730
Mr2 LSD Tranny swap? - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
MR2 LSD trans
FWD conversion components from a ST205 / Camry V6 Manual trans ( fork, plate cover, and shifter arms )
MR2 LSD inner axles
alltrac Outer axles
Clutch for MR2 turbo / alltrac
ST205 shifte...
FWD conversion components from a ST205 / Camry V6 Manual trans ( fork, plate cover, and shifter arms )
MR2 LSD inner axles
alltrac Outer axles
Clutch for MR2 turbo / alltrac
ST205 shifte...
Topic ID: 77049 • Post ID: 9540521
GT caliper brackets for front. - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
on OEM ( USDM ) calipers the bracket can be used on either side, but the actual caliper can't as the bleed valve would end up upside down, making the bleeding process a pain.
Topic ID: 77038 • Post ID: 9540441
Christmas for the Celica - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
you mean the huge banner right on the top that says FREE SHIPPING AND 15% off ?
Topic ID: 77031 • Post ID: 9540372
Christmas for the Celica - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
just FYI, not too long ago, they were being sold for ~ 260 EACH
I got mine on a GB that a member here organized for 250 shipped for both.
but other than that GB, the normal price for them was ~ 260 ea...
I got mine on a GB that a member here organized for 250 shipped for both.
but other than that GB, the normal price for them was ~ 260 ea...
Topic ID: 77031 • Post ID: 9540358
Christmas for the Celica - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
I have both, some people prefer rear only, I have no experience with the rear only, but I love the way the car feels with both, but again, can't compare.
Topic ID: 77031 • Post ID: 9540354
Christmas for the Celica - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
sway bars, not only because they have the greater of the impact on the overall performance of the suspension, but because companies are stopping to manufacturer them, if you look hard enough you'll fi...
Topic ID: 77031 • Post ID: 9540352
3sgte downpipe - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Forced Induction
QUOTE (black13 @ Dec 9, 2010 - 12:05 AM)
The berk one looks great and seems to have the improved sleeve that yellowchinaman was saying. Has a flex pipe built in though and my front pipe already has a ...
The berk one looks great and seems to have the improved sleeve that yellowchinaman was saying. Has a flex pipe built in though and my front pipe already has a ...
Topic ID: 77005 • Post ID: 9540201
Intercooler Water Pump Question - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Forced Induction
QUOTE (Driveby @ Dec 8, 2010 - 1:38 AM)
What is wrong with the old pump? If its noisey then its most likely to be the bearings worn (a common fault) which is easily and inexpensively repaired.
where ...
What is wrong with the old pump? If its noisey then its most likely to be the bearings worn (a common fault) which is easily and inexpensively repaired.
where ...
Topic ID: 77002 • Post ID: 9540174
FS: 3 point Strut braces front and rear - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Buying/Selling
1. Culpable04 ( harness bar for me )
Topic ID: 76996 • Post ID: 9540073
FS: 3 point Strut braces front and rear - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Buying/Selling
just so everyone knows, I've seen his welding skills first hand and is superb,
Art, if you want we can meet up and you can take measurements and stuff out of both of my strut braces ( front and rear )...
Art, if you want we can meet up and you can take measurements and stuff out of both of my strut braces ( front and rear )...
Topic ID: 76996 • Post ID: 9540022
Humming Noise coming from motor - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Forced Induction
he says he can hear it with the car off and key at ON position, so it has to be the fans. fuel pump doesn't start working until you crank the engine, and there is nothing else spining unless you hard ...
Topic ID: 76983 • Post ID: 9539858
black friday... - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
Other
› Off Topic
beats by Dr Dre -Studio
Topic ID: 76890 • Post ID: 9538962
94-99 GT Front Wheel Bearing Measurements - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
there is enough room to bore the knuckle to take a bigger bearing, just keep in mind that, in the case of the integras, you'd then have a 5 x 114.5 bolt patern on the front and different on the back.
...
...
Topic ID: 76841 • Post ID: 9538371
94-99 GT Front Wheel Bearing Measurements - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
that won't work, the bearing has to be pressed in, meaning, the tolerance is very critical for the performance of the bearing, once the bearing is under pressure ( on the ground and running ) that sma...
Topic ID: 76841 • Post ID: 9538368
94-99 GT Front Wheel Bearing Measurements - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
I have visitors so it'll take me a few days to get to this, but as soon as I get a new wheel bearing I'll take the measurements.
Topic ID: 76841 • Post ID: 9538359
94-99 GT Front Wheel Bearing Measurements - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
I need a new one, and will get it tomorrow, once I get it, I'll take all the measurements.
why do you need them tho ?
why do you need them tho ?
Topic ID: 76841 • Post ID: 9538356
17X8 ENKEI RPF1 with 45 offset - Pics/Info - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
no, they won't clear
you need ET35
that's ET42 WITH 15 mm spacer, when my ball joint when bad, the wheel was touching the caliper, that's how little playing room I had,
now I have Oz superleggera 17 x...
you need ET35
that's ET42 WITH 15 mm spacer, when my ball joint when bad, the wheel was touching the caliper, that's how little playing room I had,
now I have Oz superleggera 17 x...
Topic ID: 76836 • Post ID: 9538291
Gutted 6G hatch that could trap 150mph in the 1/4 which brake kit? - 6G Celicas Forums
EnthusiastJoined Apr 17, '06From New JerseyCurrentlyOfflineReputation:105(100%)
6th Generation Celica
› Suspension/Handling/Braking
those 500 bucks can lighten up another section of the car other than the front disc.
I looked into 2 piece brake disc, and unless I was getting them from sponsors for free, I would never pay for them.
I looked into 2 piece brake disc, and unless I was getting them from sponsors for free, I would never pay for them.
Topic ID: 76825 • Post ID: 9538201
Showing page 20 of 206 (4,102 total posts)