📝 skogs's Posts
Vacuum lines - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I currently have two seperate vacuum lines running from the engine bay and to a boost gauge and a boost controller inside the car. They are connected via two T-pieces spliced into the dump valve vacuu...
Topic ID: 93624 • Post ID: 9954561
convert US low beam behaviour to euro - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Interior/Audio/Electrical/Wiring
I've grown tired of forgetting to turn on the low beams on my imported ST205, so i want to change their behaviour so that they're normally on, like in my euro AT200.
I's it as simple as to replace the...
I's it as simple as to replace the...
Topic ID: 93617 • Post ID: 9954520
Loud knock when braking - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
When the brake is engaged, there is a loud knock coming from the right front wheel. If i brake again right after, the noise is barely noticable, but if i wait a while and then brake the same loud knoc...
Topic ID: 93216 • Post ID: 9943195
Rattling interior - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Interior/Audio/Electrical/Wiring
Currently i'm driving around in my GT4 with Tein SS and no stereo on ridiculously bumpy roads, and the rattling drives me..well, slightly annoyed sometimes. I have dampened the whole car with silent c...
Topic ID: 92844 • Post ID: 9940482
Stripping down a 3sgte transmission - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Thanks a lot, this really helps!
So i should drain the gear oil before removing the axles then. And be careful not to wreck the spine when pulling the engine from the transmission. The starter bolts i...
So i should drain the gear oil before removing the axles then. And be careful not to wreck the spine when pulling the engine from the transmission. The starter bolts i...
Topic ID: 92698 • Post ID: 9939578
Stripping down a 3sgte transmission - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I have a complete 3sgte engine still attached to the subframe and transmission, which i have to strip down so i can ship the transmission. I have never done this before, so i just wonder if there is a...
Topic ID: 92698 • Post ID: 9939574
Tires worn out ridiculously fast - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
A workshop swapped the motor and entire drivetrain from a jdm gt4 to my gt4. When they did the job the 19" was on it. When i got it back i almost immidiatly changed to 16" with new tires. I just wonde...
Topic ID: 92573 • Post ID: 9938691
Tires worn out ridiculously fast - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
I switched from 19" wheels to 16". Could this be enough to cause this?
Topic ID: 92573 • Post ID: 9938689
Tires worn out ridiculously fast - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
I bought a new set of tires about 2 weeks ago, after 2000km the front tires looks like this:
Front tires
The rear tires doesnt look worn at all. What is wrong?
Front tires
The rear tires doesnt look worn at all. What is wrong?
Topic ID: 92573 • Post ID: 9938687
air to fuel ratio - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I grew a pair and did some runs while having an eye on the a/f-gauge. And the ratio drops to around 10 when flooring it. Very safe then:)
Topic ID: 92449 • Post ID: 9937316
air to fuel ratio - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I get consistently 14-15 while cruising and at mild acceleration, is this critical? Or is it just at wot that it shouldnt be that high?
I dont understand why it would be a wrong ratio, i only have som...
I dont understand why it would be a wrong ratio, i only have som...
Topic ID: 92449 • Post ID: 9937315
air to fuel ratio - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
so i will be safe with this ratio?
Topic ID: 92449 • Post ID: 9937313
air to fuel ratio - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
My GT4 with a jap-spec 3sgte and euro ecu is showing typically 14-15 on my air/fuel gauge. Is this too lean? My mechanic said that i shouldnt use the jap-ecu on 95 octane... Im running 15 psi turbo pr...
Topic ID: 92449 • Post ID: 9937311
jap 3sgte in an euro st205 - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
A bolt came loose from the waterpump, and went in to the timing belt. The result was fatal for the motor.
My mechanic says that it will cost more than he first quoted, because of differences he didnt ...
My mechanic says that it will cost more than he first quoted, because of differences he didnt ...
Topic ID: 92304 • Post ID: 9936227
jap 3sgte in an euro st205 - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hi, i have imported an rhd st205 from japan to put in my lhd st205. Is there any differences that can interfere with this swap?
Topic ID: 92304 • Post ID: 9936225
3sgte Japan vs Euro ECU-wiring - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Interior/Audio/Electrical/Wiring
Can i simply replace my stock ECU with the jdm ECU? Without any further adjustments?
Topic ID: 92099 • Post ID: 9934351
3sgte Japan vs Euro ECU-wiring - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Interior/Audio/Electrical/Wiring
I'm swapping a 3sgte from a rhd st205 to a lhd st205. My mechanic says that the wiring in my car has been tampered with, and is useless. Is it possible to use the entire ecu-wiring harness from the rh...
Topic ID: 92099 • Post ID: 9934349
powered windows identical to manual? - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› General Discussion
It was the same, i didnt think it would be so thanks!
Topic ID: 92077 • Post ID: 9934156
powered windows identical to manual? - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› General Discussion
The handle is placed an inch from the door-wooofer, its a real pain in the ... imo.
A guy with a GT4 wants to buy the window glass from my 97`celica. If no one know for sure if they will fit, i will h...
A guy with a GT4 wants to buy the window glass from my 97`celica. If no one know for sure if they will fit, i will h...
Topic ID: 92077 • Post ID: 9934154
powered windows identical to manual? - 6G Celicas Forums
EnthusiastJoined Apr 19, '08From NorwayCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› General Discussion
Does anyone know if the window panes on a celica with powered windows are similar to the manual ones?
Topic ID: 92077 • Post ID: 9934151
Showing page 3 of 7 (139 total posts)