📝 msk59's Posts
FS: Megan coilovers, rear ss-iii jdm splitters, and more! - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
I want that exhaust so second dibs if the first person does not buy it.
Topic ID: 96398 • Post ID: 9973279
F/S GT4 Bumper (Turns/Grills/Support/Latch) and a few misc parts. - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
Can you pm me the prices and post some pictures of the depot lights (turn signals). I have a 1996 ST and the originals are very foggy.
Topic ID: 96374 • Post ID: 9973100
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Sorry Bitter for the delayed response. I was TDY. I cleared the codes after i installed the new O2 sensor. Since I drove about 230 miles and no lights so far. So it must have been the O2 malfunctionin...
Topic ID: 96367 • Post ID: 9973079
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Ok the light is back ON after installing the new O2 sensor. Can someone please tell me how to systematically check the system to see where is the issue. Obviously, it is not the O2 sensor. I will chec...
Topic ID: 96367 • Post ID: 9973077
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Update: Installed the new O2 Sensor last night. drove around the block, no check engine light. Drove to work this morning about 18 miles no check light, so will see on the way back if it does turn the...
Topic ID: 96367 • Post ID: 9973076
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Thanks, I think it is direct fit as I checked the local Advance Auto and O'Rielly and the sell the same part for 58 dollars. So it does have a plug two pin.
Thanks again.
Thanks again.
Topic ID: 96367 • Post ID: 9973074
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
OK I will try that and see what happens. I found prices of replacement denso on RA really cheap. about 33 shipped.
Topic ID: 96367 • Post ID: 9973072
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
thanks I plan on replacing the O2 sensor after i check the connections and wiring.
Topic ID: 96367 • Post ID: 9973070
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
OK after several gaskets I finally had to replace the studs on the header and install new gaskets. No leaks but the engine check light keep coming on after about 20 miles of driving. The O2 is still t...
Topic ID: 96367 • Post ID: 9973068
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Cheela: Thanks that was my second option.
Igpx12:
Awesome thanks a million!
This post has been edited by
msk59
: Jan 14, 2016 - 10:37 AM
Igpx12:
Awesome thanks a million!
This post has been edited by
msk59
: Jan 14, 2016 - 10:37 AM
Topic ID: 96367 • Post ID: 9973067
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hello Guys: I am facing a new issue. After I discovered the leak (bad gasket) between the eBay header and the down pipe, I am stuck without a gasket. No one, even the seller does not offer spare gaske...
Topic ID: 96367 • Post ID: 9973064
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
You are so right about the junk gasket and this whole eBay crap headers as well. First it did not fit, I had to drill holes bigger to make it fit. Then the down-pipe was short. That got fixed then it ...
Topic ID: 96367 • Post ID: 9973063
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Thank You. I pulled the header out and notice the header to down pipe gaskit is leaking already. Perhaps I did not tighten the bolts correctly. So waiting for a different new gasket from O'Rielly and ...
Topic ID: 96367 • Post ID: 9973061
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Not sure I understand what you are saying. The downpipe that came with the header was short in terms of reaching the cat. So I took it to the shop and added a piece that took care of that. There is no...
Topic ID: 96367 • Post ID: 9973059
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (Smaay @ Jan 8, 2016 - 1:39 PM)
did you put the O2 sensors back in?
did you swap them?
Yes, It is back in and I had to use the oval type flange to put it back in. I did not swap the 02 sensors. ...
did you put the O2 sensors back in?
did you swap them?
Yes, It is back in and I had to use the oval type flange to put it back in. I did not swap the 02 sensors. ...
Topic ID: 96367 • Post ID: 9973057
Code P0130 adn p0133 - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hello: After installing the header and getting it all set, I am getting these two codes. I reset them once and these two come back again. I will check for leaks etc and the reading on the first O2 sen...
Topic ID: 96367 • Post ID: 9973054
WTB: Stock Exhaust Parts 94-95 7a-fe - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
I sent you pictures of my setup. My car has no cat in the manifold thus a shorter manifold and longer downpipe. The flange is in the down pipe.
Topic ID: 96362 • Post ID: 9973027
WTB: Stock Exhaust Parts 94-95 7a-fe - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
I think it fits. The header I am installing in my car is actually made for Corolla. It had a oval shaped bung on it for O2 sensor. different than mine and I was able to buy that adapter and my O2 scre...
Topic ID: 96362 • Post ID: 9973023
WTB: Stock Exhaust Parts 94-95 7a-fe - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
On the 1996 STs, the O2 sensor is screw in type. There is a nut welded on the downpipe up front near the header where the O2 goes (if I remember correctly). I will take some pictures since it is out o...
Topic ID: 96362 • Post ID: 9973021
WTB: Stock Exhaust Parts 94-95 7a-fe - 6G Celicas Forums
EnthusiastJoined May 10, '14From Tulsa, OKCurrentlyOfflineReputation:5(100%)
6th Generation Celica
› Buying/Selling
Give me a few days as I just took off mine OEM from my 1996 ST, no leaks no noise I just wanted to put headers on and downpipe. I am taking it in today to shop to get the new downpipe fixed as it is t...
Topic ID: 96362 • Post ID: 9973019
Showing page 6 of 25 (500 total posts)