📝 KAOS's Posts
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (mi645 @ Jul 21, 2014 - 1:32 AM)
kaos show us a picture of the transmission its most likely an e series if the 3sgte clutch kit fit.
Check out my build thread, the last few posts have the pictur...
kaos show us a picture of the transmission its most likely an e series if the 3sgte clutch kit fit.
Check out my build thread, the last few posts have the pictur...
Topic ID: 91406 • Post ID: 9928245
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Any one here doing the 3SGE into a St204 use the S54 transmission from the 3SGE?
What pressure plate, flywheel, and friction disc did you use?
I used a 3SGTE flywheel and a clutch kit for a 3SGTE and ...
What pressure plate, flywheel, and friction disc did you use?
I used a 3SGTE flywheel and a clutch kit for a 3SGTE and ...
Topic ID: 91406 • Post ID: 9928242
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (mi645 @ May 27, 2014 - 5:43 PM)
everything is plug and play, and yes the harness reaches with no problems just make sure u put new shield and wiring tape for safety, and no u dont have to re pi...
everything is plug and play, and yes the harness reaches with no problems just make sure u put new shield and wiring tape for safety, and no u dont have to re pi...
Topic ID: 91406 • Post ID: 9928241
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (mi645 @ May 16, 2014 - 12:11 AM)
i didnt extend mine, i simply took all the factory tape off re routed everything tape it back up, put the shields on and thats about it, i only extended ignite...
i didnt extend mine, i simply took all the factory tape off re routed everything tape it back up, put the shields on and thats about it, i only extended ignite...
Topic ID: 91406 • Post ID: 9928239
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Anyone who lengthened their harnesses, how much did you have to lengthen it by? I'm thinking around 4 feet should do the trick, but I don't know...
Thoughts? Where did everyone go on this topic?
Thoughts? Where did everyone go on this topic?
Topic ID: 91406 • Post ID: 9928234
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Anyone make any progress on their swaps?
Topic ID: 91406 • Post ID: 9928233
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
Next large task on my agenda:
Figuring out the axels. I was told at one point that we could just use the 5SFE axels in the 3S - which is all good with me, but what about the driveshaft bearing on the ...
Figuring out the axels. I was told at one point that we could just use the 5SFE axels in the 3S - which is all good with me, but what about the driveshaft bearing on the ...
Topic ID: 91406 • Post ID: 9928231
3rd Gen 3S-GE swapping information thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (H8TRAIN @ Dec 16, 2013 - 8:21 PM)
Thanks mi645, czwalga, 99gt3sge and rusty for helping make this the most informative page on the whole internet about this subject!
No doubt. I have been so fr...
Thanks mi645, czwalga, 99gt3sge and rusty for helping make this the most informative page on the whole internet about this subject!
No doubt. I have been so fr...
Topic ID: 91406 • Post ID: 9928230
FS: Part out 94 ST204 - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Buying/Selling
I need the fuel line, runs from the injectors to the filter. Including all banjo bolts etc.
Pics first preferably. Thanks!
Pics first preferably. Thanks!
Topic ID: 91378 • Post ID: 9927985
Rev 3 3sge swap help - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
What if the clutch starter pin/wire was possibly bypassed (during the 5SFE days) for command start?
Would this be affected in the swap? I haven't gotten to the wiring of my 3SGE yet, but I'm very inte...
Would this be affected in the swap? I haven't gotten to the wiring of my 3SGE yet, but I'm very inte...
Topic ID: 91364 • Post ID: 9927684
Wtb 3sge fuel line - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Buying/Selling
Umm. Me too
Topic ID: 91300 • Post ID: 9927203
Red Top Beams cold start issue - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (richee3 @ Dec 12, 2013 - 12:33 AM)
That's a VSV on the intake elbow. It just lets fumes from the charcoal canister into the intake. You should have three small vacuum lines- one going from the ...
That's a VSV on the intake elbow. It just lets fumes from the charcoal canister into the intake. You should have three small vacuum lines- one going from the ...
Topic ID: 91265 • Post ID: 9926705
st 205 Restoration Project - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› My Project
Good to see you still have the car, brother!
Hope to hear more from you soon!
Hope to hear more from you soon!
Topic ID: 91022 • Post ID: 9925460
35 and older thread - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› General Discussion
Just hit 31 in November.
Will have my Celica forever though...
Will have my Celica forever though...
Topic ID: 90899 • Post ID: 9924092
Reducing Understeer - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Suspension/Handling/Braking
Sorry, I think the point of this topic wasn't clearly communicated.
I wanted to tell my buddy that he was out of his mind.
(a) not RACECAR
(b) never will be driven to the extremes that I would ever ex...
I wanted to tell my buddy that he was out of his mind.
(a) not RACECAR
(b) never will be driven to the extremes that I would ever ex...
Topic ID: 90881 • Post ID: 9923875
Reducing Understeer - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› Suspension/Handling/Braking
I'm looking for some advice. The engine is almost back in the car, and I then need to finish the chassis upgrades.
I have a ST front sway bar to install and my friend seems to think that if I remove t...
I have a ST front sway bar to install and my friend seems to think that if I remove t...
Topic ID: 90881 • Post ID: 9923866
A Box and His Celica - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› My Project
QUOTE (1994Celica @ Nov 20, 2013 - 9:55 AM)
QUOTE (KAOS @ Nov 20, 2013 - 12:35 PM)
QUOTE (Box @ Nov 18, 2013 - 12:06 PM)
Mine are the 94-95, and we have the GT and GT-S here. Though over here the sea...
QUOTE (KAOS @ Nov 20, 2013 - 12:35 PM)
QUOTE (Box @ Nov 18, 2013 - 12:06 PM)
Mine are the 94-95, and we have the GT and GT-S here. Though over here the sea...
Topic ID: 90827 • Post ID: 9923237
A Box and His Celica - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› My Project
QUOTE (Box @ Nov 18, 2013 - 12:06 PM)
Mine are the 94-95, and we have the GT and GT-S here. Though over here the seats are the same between the two aside from materials used and they don't have airba...
Mine are the 94-95, and we have the GT and GT-S here. Though over here the seats are the same between the two aside from materials used and they don't have airba...
Topic ID: 90827 • Post ID: 9923235
And...We're back! - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› General Discussion
Hells yea.
Amazing that you realize what you've got when you don't have it anymore...
Thanks Coomer & Manny for pestering him.
Amazing that you realize what you've got when you don't have it anymore...
Thanks Coomer & Manny for pestering him.
Topic ID: 90739 • Post ID: 9922256
cant believe im saying this - 6G Celicas Forums
EnthusiastJoined Apr 18, '06From Calgary, CanadaCurrentlyOfflineReputation:37(100%)
6th Generation Celica
› General Discussion
Kurt; even though I've never driven in a V6 swapped 6Gen, I'm still very inspired by your swap.
I think on FB someone was trash talking my build and I was just like, "0.o - ok, whatever dweeb". Smack ...
I think on FB someone was trash talking my build and I was just like, "0.o - ok, whatever dweeb". Smack ...
Topic ID: 90727 • Post ID: 9922185
Showing page 7 of 117 (2,335 total posts)