📝 pitcelica's Posts
pitcelica
📍 Québec, Canada
Member
Posts
170
Vehicles
0
A quest for all 3rd gen 3sgte owners! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
Good, thanks man!
I just need an approximation. I want to know if its more near 20 degrees or near 15 degrees. Dont forget to look at your RPM at idle and at your in/hg number on your boost gauge. Do ...
I just need an approximation. I want to know if its more near 20 degrees or near 15 degrees. Dont forget to look at your RPM at idle and at your in/hg number on your boost gauge. Do ...
Topic ID: 55818 • Post ID: 8447519
A quest for all 3rd gen 3sgte owners! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
bump, cmon its a easy test!
Topic ID: 55818 • Post ID: 8447517
A quest for all 3rd gen 3sgte owners! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
Hi, I have a little test that I want you to perform on your engine. I want to do it for my personal knowledge, but I will share it with everyone else on this board or on other forum.
I want you to tak...
I want you to tak...
Topic ID: 55818 • Post ID: 8447516
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
yes it has oil squirter, I have a spare gen4 head at home. I'll check for the stainless valves and the angle cut. I'll post close pics of valves and head.
Topic ID: 54226 • Post ID: 8388692
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
Ok, thanks,
I was thinking that the side feed or top feed was only the fuel rail setup:
If the rail receive fuel from one end to the other, this was a side feed fuel rail.
If the rail receive fuel fro...
I was thinking that the side feed or top feed was only the fuel rail setup:
If the rail receive fuel from one end to the other, this was a side feed fuel rail.
If the rail receive fuel fro...
Topic ID: 54226 • Post ID: 8388687
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
Here's a pic of the cam sensor and trigger shaft mentionned above :
Topic ID: 54226 • Post ID: 8388685
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
The 4th gen fuel rail isn't top feed. The fuel enters from one end and go back to the tank at the opposite end.
Here's a pic of the ST205 fuel rail and injectors :
Here's a pic of the ST215 fuel rail ...
Here's a pic of the ST205 fuel rail and injectors :
Here's a pic of the ST215 fuel rail ...
Topic ID: 54226 • Post ID: 8388684
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
So, as I can seen, a lot of people want to know what are the aftermarket parts are available for the ST215 3SGTE engine. Here's are some parts that are bolt on :
-Adjustable cam gear (AEM, Fidanza, HK...
-Adjustable cam gear (AEM, Fidanza, HK...
Topic ID: 54226 • Post ID: 8388681
400whp caladina powered FF 6gc - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
I know that the exhaust cam is the same as ST185 and ST205. Here's my guess for the intake cam :
Specs of stock ST185 cams:
Ex, max cam lift 8.2 mm, 236°, max lift at 118° BTDC, open 56° BBDC, close 0...
Specs of stock ST185 cams:
Ex, max cam lift 8.2 mm, 236°, max lift at 118° BTDC, open 56° BBDC, close 0...
Topic ID: 54226 • Post ID: 8388674
2zz swap? - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
I think that some of you don't understand what is real HP and real Torque.
Torque is rotational force.
Torque formula :
T = R x F
R = radius (wheel diameter/2 for WHP)
F = Force applied on a certain p...
Torque is rotational force.
Torque formula :
T = R x F
R = radius (wheel diameter/2 for WHP)
F = Force applied on a certain p...
Topic ID: 54045 • Post ID: 8385977
lots of st205 wrc action - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Multimedia
Is it normal that, in the description, they said that the tranny was a 6 speed? Is this true? Does ST205 WRC were available with a 6 speed awd tranny?
Let me know!
Let me know!
Topic ID: 53937 • Post ID: 8377373
replacing the clutch - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Engine/Transmission/Maintenance
You can use hard harmering against this cup. It's make of steel and will not pry or broke easily. You're not oblige to remove it. Let it in the tranny and when the tranny will be down, you will have e...
Topic ID: 53878 • Post ID: 8376448
supershannon77's new 5SFTE powered celica - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
I have bought the F1 racing stage 3 clutch kit + lightweight flywheel like this one :
http://cgi.ebay.ca/F1-STAGE-3-CLUTCH-KIT-R...p3286.m20.l1116
I have nothing wrong to say about it : it holds my po...
http://cgi.ebay.ca/F1-STAGE-3-CLUTCH-KIT-R...p3286.m20.l1116
I have nothing wrong to say about it : it holds my po...
Topic ID: 52431 • Post ID: 8253272
supershannon77's new 5SFTE powered celica - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
ok, thanks for the pics... I'll try to investigate my problem deeper. For now, I relocated the BOV right after the turbo outlet, before the FMIC, no change. I removed the intercooler because I though ...
Topic ID: 52431 • Post ID: 8253115
supershannon77's new 5SFTE powered celica - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
i mean, you certainly not go into boost each time you ride your car. When you aren't boosting it, when you shift only at 3000 RPM, do you have compressor surge... This is my case, and because you have...
Topic ID: 52431 • Post ID: 8253113
supershannon77's new 5SFTE powered celica - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
do you have compressor surge at low boost with this setup? I have the same turbo kit, near the same intercooler path and the bov is located at the same place and I have compressor surge... I'm using a...
Topic ID: 52431 • Post ID: 8253111
Engine Pics! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Multimedia
could you give me what is the lenght of your vaccum line and what is his inside diameter? Would you like to give me the lenght of your intercooler piping and the I.D. All those infos will help me to s...
Topic ID: 52069 • Post ID: 8248612
Engine Pics! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Multimedia
I'm running an ebay t3-t4 .50 comp AR, .63 turbine AR.
I adjusted the spring all the way out (no preload on the spring) and the BOV do not response enough fast to kill compressor surge... Could you ta...
I adjusted the spring all the way out (no preload on the spring) and the BOV do not response enough fast to kill compressor surge... Could you ta...
Topic ID: 52069 • Post ID: 8248611
Engine Pics! - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Multimedia
hey TRD-GT4, do you have compressor surge with this BOV on your setup at low boost (from 0 to 4 psi)? I have the same BOV, located at the same place on the intercooler piping and I have near the same ...
Topic ID: 52069 • Post ID: 8248608
Toyota Caldina - 6G Celicas Forums
EnthusiastJoined Jan 28, '07From Québec, CanadaCurrentlyOfflineReputation:1(100%)
6th Generation Celica
› Forced Induction
great idea!!!
Topic ID: 50672 • Post ID: 8155293
Showing page 8 of 9 (170 total posts)