📝 Dunners's Posts
Dunners
📍 Brisbane, Australia
Member
Posts
32
Vehicles
0
Clutch Pedal - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guy's,
Just wondering if anyone else's clutch pedal is hard to push in. I've never really noticed it but I drove a mates toyota the other day and his was so easy. Is there anything that determines...
Just wondering if anyone else's clutch pedal is hard to push in. I've never really noticed it but I drove a mates toyota the other day and his was so easy. Is there anything that determines...
Topic ID: 39749 • Post ID: 7580232
Sounds from the steering system - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Could it be your outer CV joint? Good Luck.
Topic ID: 37111 • Post ID: 7340305
i know, it sucks - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
That happened to me on my old car, it ripped the thread out. I just put a bit of locktite round a new plug and put it in cause it wasn't worth fixing it. It was still going strong when i put it in the...
Topic ID: 34461 • Post ID: 7181790
CV boot is craked? - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Just replace the whole axel,I just got a rebuilt axle with new inner and outer cv's. it's not that hard and it's easier than mucking round pulling the joint apart. It was 180 bucks for the axle (but i...
Topic ID: 34263 • Post ID: 7179057
car over-heated!!!!! - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Is there any black or white smoke coming out the exhaust? if you're head gasket's really bad you should see some exhaust smoke. but it could be only partially gone and the coolant and oil are mixing. ...
Topic ID: 34246 • Post ID: 7123774
HELP dead cylinder - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Doesn't continuous flashing mean that it has no codes to throw? I could be wrong. good luck.
Topic ID: 34221 • Post ID: 7123371
Pcv Valve - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
She'll be right, I took the valve out of the valve cover when it was out of the car and glued and let it dry before i put it back in.thanks for the reply
Topic ID: 34141 • Post ID: 7122330
Pcv Valve - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guy's,
Just finished putting the new gasket on, This is the first gasket i've done. Is there usually a bit of a burning smell? It's definetely not oil, i thought it might just be the new gasket. I...
Just finished putting the new gasket on, This is the first gasket i've done. Is there usually a bit of a burning smell? It's definetely not oil, i thought it might just be the new gasket. I...
Topic ID: 34141 • Post ID: 7122328
Pcv Valve - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guy's,
I was just replacing my valve cover gasket and when i took the hose off the pcv valve that runs to the intake manifold the stupid thing broke. Just wondering what exactly the pcv does and h...
I was just replacing my valve cover gasket and when i took the hose off the pcv valve that runs to the intake manifold the stupid thing broke. Just wondering what exactly the pcv does and h...
Topic ID: 34141 • Post ID: 7122327
Brake pad problems - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Thanks guy's, they're discs front and back. i'll have a look at fixing it sometime soon. cheers again.
Topic ID: 33880 • Post ID: 7118950
Brake pad problems - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Hi guy's,
I replaced my front and rear brake pads about 6 months ago. In the front i put good quality ones that cost around 90 bucks. they're going really good. In the back i put ones in that cost aro...
I replaced my front and rear brake pads about 6 months ago. In the front i put good quality ones that cost around 90 bucks. they're going really good. In the back i put ones in that cost aro...
Topic ID: 33880 • Post ID: 7118947
Smoke!!!!!!!!!! - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Is there any smoke coming out the exhaust? oil might just be slipping past the oil seal and dripping into the exhaust housing, it would explain any smoke coming out the turbo or cat. I don't know why ...
Topic ID: 33396 • Post ID: 7101316
Oil leak - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I only had a quick look but i'm pretty sure it's engine oil. The back of the valve cover gasket makes sense. I might get under there with a can of degreaser and try and isolate it then look into chang...
Topic ID: 33230 • Post ID: 7099112
Oil leak - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guy's, i appologise in advance for the vagueness of this post but when i was changing the oil this arvo i had a look up behind the engine and there was a fair bit of oil all on the runners going f...
Topic ID: 33230 • Post ID: 7099107
Driveaxle changeover - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Thanks for all your help guy's, I'm pretty sure i was imagining that vibration and if i wasn't it's gone now. They used new joints for both inner and outer and looked as if it had been done well. If I...
Topic ID: 31616 • Post ID: 7057020
Driveaxle changeover - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
oh ok thanks for your help, Can i just keep that one in there or should i take it out and put the proper one in?
Topic ID: 31616 • Post ID: 7057014
Driveaxle changeover - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guys, Put in a new driver's side driveaxle and took her for a test drive and all seems ok. Although i think it may vibrate a bit more on acceleration but it can barely be noticed. Has this happene...
Topic ID: 31616 • Post ID: 7057012
Cv Joints - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hey guy's, I bought a reconditioned drive shaft with new cv joints on them and the inner joint is so much more flexible than the outer, the outer is actually quite stiff to try and move sideway's. Doe...
Topic ID: 31394 • Post ID: 7054088
Surging... - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I reckon it might be you're spark plugs, the same thing was happening to me last year and after changing the plugs it was fine. In the mean time i found that if you hold down the accelerater to 3500 r...
Topic ID: 31335 • Post ID: 7053187
5sfte aftermarket exhaust manifold prob - 6G Celicas Forums
EnthusiastJoined Oct 25, '05From Brisbane, AustraliaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I've got a stock 3sgte manifold off a mr2 and the same thing happened to me, 1 extra bolt on each side, nothing the trusty hack saw couldn't fix
Topic ID: 30577 • Post ID: 7038755
Showing page 1 of 2 (32 total posts)