📝 Sicilian_Celica's Posts
Engine code 14 - 6G Celicas Forums
EnthusiastJoined Jan 24, '22From Sicily, ItalyCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Starts up fine, but after a couple mins of running the check engine light comes on and wont rev over 3k RPMs, occasionally dies. It is displaying code 14:
"a loss of IGF signal between the ignitor and...
"a loss of IGF signal between the ignitor and...
Topic ID: 99331 • Post ID: 9994778
Celica st205 wrc motor cutting power and boost problem - 6G Celicas Forums
EnthusiastJoined Jan 24, '22From Sicily, ItalyCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE (empite @ Aug 25, 2016 - 6:58 AM)
QUOTE (Smaay @ Aug 24, 2016 - 7:54 PM)
sounds like boost cut, how much boost are you making.
9 volts is good for idle. the resistor is active at low load. at ...
QUOTE (Smaay @ Aug 24, 2016 - 7:54 PM)
sounds like boost cut, how much boost are you making.
9 volts is good for idle. the resistor is active at low load. at ...
Topic ID: 97083 • Post ID: 9977941
Showing page 1 of 1 (2 total posts)