📝 crumpdogg's Posts
crumpdogg
📍 Hotlanta
Member
Posts
18
Vehicles
0
BOMZ strut bar - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
I just put mine on yesterday. For $25, who cares about the handling(it won't be worse). I took of the stock one and the mounting brackets from the new one and painted them metal flake blue to match th...
Topic ID: 21592 • Post ID: 6376968
AIR INTAKES - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...me=STRK:MEWN:IT
I would say this was more than worth the $80 shipped. Can't see paying much more for an intake. E-bay has them all over for cheap. Don't go...
I would say this was more than worth the $80 shipped. Can't see paying much more for an intake. E-bay has them all over for cheap. Don't go...
Topic ID: 21517 • Post ID: 6376022
WTB: I need a lot of stuff 95 GT 5SFE - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
How much for just the coil-overs? If I have to buy 1 strut, I might as well get them all. Sorry, not interested in the speaker box.
Thanks.
Thanks.
Topic ID: 21013 • Post ID: 6329088
WTB: I need a lot of stuff 95 GT 5SFE - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
I just got a 6th gen celi GT for $500. Replaced timing belt, tensioner, idler, plugs, wires, dist cap and rotor, oil change, tranny flush and fill, etc. Now I am ready to PLAY!(actually $500 after all...
Topic ID: 21013 • Post ID: 6329086
Complete Tune Up - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Your topic reads "complete tune-up". I think you are forgetting a few things if you are going that route: timing belt, tensioner, idler, oil change, filter, tranny flush and fill w/filter, chassis lub...
Topic ID: 20951 • Post ID: 6328154
brake pedal goes down with no brakes - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
There is a little kit that you can get at any local auto parts store that makes bleeding the brakes fool proof. If you really have to push hard or there is a lot of travel in the pedal with no respons...
Topic ID: 20950 • Post ID: 6328128
somethin wrong with my 5s - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
What kind of car is it? Mine doesn't have a MAF sensor. Get an ohm meter and a manual and check the TPS. Also, do you have standard or auto tranny? If auto, could be a speed sensor/ adjustment.
Topic ID: 20867 • Post ID: 6327051
Does ANYONE have stainless steel brake lines? - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Good pads and SS lines is probably the best brake mod you can do(other than big brake conversion) If you were thinking of doing it, go for it, you will not be dissappointed. I have had them on many di...
Topic ID: 20720 • Post ID: 6317663
ABS lights on - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
My ABS light is on due to a bad wheel bearing in the back right hub. The sensor is getting an irratic signal. Tried to source the part, but cannot replace only the bearings in the back. They do not se...
Topic ID: 20621 • Post ID: 6316222
Suspension question - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
In stock form, a front wheel drive car, will always understeer. The only real way to fix that is with a stiffer rear swaybar. As for the suspension travel and handling characteristics, nothing will be...
Topic ID: 20566 • Post ID: 6315526
Engine importers - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
jarcoinc.com
The guys go over there every couple of months and buy pallets full of motors, parts, half cuts, etc.
The guys go over there every couple of months and buy pallets full of motors, parts, half cuts, etc.
Topic ID: 20520 • Post ID: 6314813
axle set? - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Like for brake pads, they say axle set
Yea, sorry, missed that part. If they say axle set, it should be the whole front set.
Yea, sorry, missed that part. If they say axle set, it should be the whole front set.
Topic ID: 20477 • Post ID: 6314338
axle set? - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
axle set is for both sides of an "axle," so left and right. you would just buy one set.
You nailed it!
But, make sure you look in the box before you buy. The axles should be different lengths.
You nailed it!
But, make sure you look in the box before you buy. The axles should be different lengths.
Topic ID: 20477 • Post ID: 6314336
Are these a good buy? - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Honestly, you could do the axles in the apartment parking lot as well. But, I digress. Get the suspension stuff anyway. While you are doing the axles, you can swap the springs and struts in no time an...
Topic ID: 20445 • Post ID: 6313902
wheel bearins - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
Pressing bearings in and out is not that difficult. If you have access to a press, you will save some $$ but not that much. $150 for both is not that bad. One front bearing costs almost $40, so you wo...
Topic ID: 20400 • Post ID: 6313398
bilstein? - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
I have Bilsteins on my Expedition, but can't find the for the celi anywhere. Where did you find them?
Topic ID: 20299 • Post ID: 6312101
need help selecting rims - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
By the way Droptop
That celi is tight. New rims would set it off.
That celi is tight. New rims would set it off.
Topic ID: 18971 • Post ID: 6151961
need help selecting rims - 6G Celicas Forums
EnthusiastJoined Jan 25, '05From HotlantaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
I haven't seen any older celi's with the new GTS rims. I think that would look pretty good for a cheap price.
Topic ID: 18971 • Post ID: 6151960
Showing page 1 of 1 (18 total posts)