📝 jaxx6GC's Posts
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I Finally got my exhaust redone earlier this month. I went with a 4-inch exit cannon and had my factory resonator and secondary cat deleted. I also replaced everything from the header back with 2.25. ...
Topic ID: 98717 • Post ID: 9991012
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
So I've done a few small things since My last post. I finally replaced the bad sender to my oil gauge and repainted my battery hold down. I also scored a Griproyal Grain and a NRG quick release for my...
Topic ID: 98717 • Post ID: 9991011
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I'm probably going to get a new bumper, carbon fibre hood, 2 post spoiler with blocks and then get some fresh paint. I'm planning a 3rd gen 3SGTE swap for next summer. I'm currently rebuilding my S13 ...
Topic ID: 98717 • Post ID: 9991009
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
So I got my wheels on a couple of weeks ago. Everything fit better than expected but I ended up having to roll the rear because of a slight rub during spirited driving. I've finally got everything sit...
Topic ID: 98717 • Post ID: 9991007
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I picked up a set of 5zigen Pro Racer GN+ wheels for a pretty good deal. One of them has a mild bend in the lip but they held air just fine so I'm not terribly worried. I polished up the lips, tossed ...
Topic ID: 98717 • Post ID: 9991004
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I actually followed your setup when I got my spacers.
I figure I'll have to roll them but hopefully they'll fit until I can rent a roller. I'm gonna lift the car a couple of inches.
I figure I'll have to roll them but hopefully they'll fit until I can rent a roller. I'm gonna lift the car a couple of inches.
Topic ID: 98717 • Post ID: 9991003
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I've got a set of bronze 5zigen Pro Racer GN+ that're 17x8.5 +48. I'm gonna get them on in a couple of days after I clean them up. I'm hoping they'll sit right with my 20mm spacers.
Topic ID: 98717 • Post ID: 9991000
Jax's ST204 Thread - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› My Project
I figured I'd make a thread on how my 6GCs coming along. I have a 1997 Celica GT that started out as a rental car in Michigan. The original owner purchased it with around 30,000 Miles and brought it d...
Topic ID: 98717 • Post ID: 9990997
WTB: 96-99 Facelift Front Bumper - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
Looking to buy a facelift front bumper in good condition. Located in Mississippi.
Topic ID: 98574 • Post ID: 9990031
WTB: Interior parts - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
I'm looking to pick up a few parts for my ST204. I'm looking for a cigarette lighter ring with bulb, Rear view mirror, ashtray, shifter bezel and din pocket for under the radio. I'll update this threa...
Topic ID: 98380 • Post ID: 9988708
WTB: IAC Idle Air Control Valve - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
I've got a brand new Airtex/Wells IAC that I bought to fix a problem that was caused by something else. It's been used for about 5 miles and works fine.
Topic ID: 97693 • Post ID: 9982866
Starting issue - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
So one morning I was about to head out and My Celica (5SFE) wouldn't start. I turn the key and all I get is a click, one loud click from the solenoid. I figured my battery was dead so I jumped it with...
Topic ID: 97579 • Post ID: 9982130
5SFE high idle issue - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Update: I changed out the throttle body (Came with a used TPS and IACV) along with a different coolant temp sensor and She runs fine now. Idles down to 850-750 RPM and Idles just below 1K with the AC ...
Topic ID: 97497 • Post ID: 9980708
5SFE high idle issue - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Update. I ordered a new throttle body after noticing the butterfly was worn way down. I doubt this will effect my Idle issue but it was something that needed addressing. I'll be replacing my coolant t...
Topic ID: 97497 • Post ID: 9980706
5SFE high idle issue - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I've tried adjusting it both ways with little effect.
Topic ID: 97497 • Post ID: 9980703
5SFE high idle issue - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
So I'm having a problem with my 97' Celica GT. One day started it up and got a CEL along with a very low rough idle. I was getting a code that my IAC was bad so I popped the hood and discovered that t...
Topic ID: 97497 • Post ID: 9980701
WTB: Sunroof motor - 6G Celicas Forums
EnthusiastJoined Oct 2, '16From Hattiesburg, MississippiCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
I'm looking for a sunroof motor and gears. Located in Mississippi, Can pay via Paypal.
Topic ID: 97352 • Post ID: 9979592
Showing page 1 of 1 (17 total posts)