📝 kgr-gts's Posts

kgr-gts

📍 Saskatoon, SK, Canada
Member
Posts
19
Vehicles
1

Cali emissions - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › General Discussion
Looking at the wiring diagrams (5SFE), the wiring to the injectors is different, and there is a 2nd O2 sensor (I've got 1).
Is it possible that switching to a US GT-spec exhaust system might be enough...
Topic ID: 27502 • Post ID: 6700931

Cali emissions - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › General Discussion
Hi all,
I've got a Canadian GTS and I want to take it to California with me. I know there are several differences in the engine wiring, an additional O2 sensor, etc.
I know it's probably easy to sell...
Topic ID: 27502 • Post ID: 6700929

lil problem i need help w/ - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Engine/Transmission/Maintenance
QUOTE(94CelicaRedHatch @ Jul 1, 2005 - 4:51 AM)
my car idles higher than normal when my AC is on, never thought much of it
[right][snapback]307149[/snapback][/right]
well at least *yours* is working p...
Topic ID: 26419 • Post ID: 6619045

lil problem i need help w/ - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Engine/Transmission/Maintenance
QUOTE(Toad @ Jun 30, 2005 - 8:17 PM)
There's probalby some simple answer to this but i need some help. I'm wondering whats the matter w/ the car. Its idling fine, but when the ac's on the steering whe...
Topic ID: 26419 • Post ID: 6619041

lil problem i need help w/ - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Engine/Transmission/Maintenance
The A/C is supposed to activate an idle-up circuit when the compressor is engaged. It should raise your idle *above* normal. The shop manual says 750rpm without the compressor going and 850rpm when ...
Topic ID: 26419 • Post ID: 6619033

3SGTE Swap Questions - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Engine/Transmission/Maintenance
I used to drive a turbo car (Merkur XR4Ti) and I really miss the balls it had. That and I just got a raise and money burns a hole in my pocket. It's time to turn my Celica into the car it was suppos...
Topic ID: 26279 • Post ID: 6616592

WTB: OEM foglight connector - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Buying/Selling
I'm adding OEM fogs to my 94 and I'm looking for the following:
The connector from a 96+ wiring harness that connects to the turn signal/headlamp/foglight switch.
I can buy the switch at the dealer, b...
Topic ID: 26148 • Post ID: 6615394

Adding OEM fogs to 94/95 - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
I don't have the switch yet. I'm going to buy the factory switch on the headlight stalk. I believe it's a ring like the intermittent wiper adjust on the other side.
My first thought was to wire it u...
Topic ID: 26028 • Post ID: 6613722

Adding OEM fogs to 94/95 - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
Hey all,
Some idiot smacked my front bumper so I'm replacing it with the 96-style cover. I'm getting the fog lights as well and I'd like comments from people who have added OEM fogs to a 94/95 car. ...
Topic ID: 26028 • Post ID: 6613720

Interior roof and door lights - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
hey guys,
i've been trying to remove the roof light plastic piece as well. i took out the screw, but the thing still won't budge. it's as if it's attached another way as well.
are you sure it's just...
Topic ID: 15602 • Post ID: 5315328

Soldering in LED's - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
ok, so if I only want to replace the A/C light with a blue LED, I don't have to worry about adding a resistor, correct?
The resistors are just for the 3 bulbs that provide the illumination?
I'm going ...
Topic ID: 15318 • Post ID: 5282607

remote starter on manual transmission - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
Well, you have a few options here:
1) Buy a "manual transmission" starter. With these, you have to put the car in neutral, get out, and shut the door. The car will shut itself off and arm the syste...
Topic ID: 13685 • Post ID: 5256806

Window positioning - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
aren't the window stops only used for adjusting how high the window goes up? the window goes up to the correct height, but I need to move it forward and tilt the front end down slightly. the shop ma...
Topic ID: 12920 • Post ID: 5244751

Window positioning - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
that's weird. you make it sound like the window should be completely free to move once i loosen those bolts. ("have somebody hold it")
i can't move it at all. i loosen the bolts and it just sits th...
Topic ID: 12920 • Post ID: 5244748

Window positioning - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
thanks for the info.
I tried to adjust the window by loosening those 3 bolts on the carrier, but it won't budge. how much force am i supposed to put on it? it feels like i'm going to bust something ...
Topic ID: 12920 • Post ID: 5244746

Window positioning - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
Hey guys,
I had an air leak in my passenger side window so I had to move it around a bit. (I think it was put in the wrong place when the doorlock was repaired)
I've stopped the air leak, but now as ...
Topic ID: 12920 • Post ID: 5244742

Factory fog light wiring on 94 - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Interior/Audio/Electrical/Wiring
Hey guys,
I'm planning on adding factory fogs to my 94 (with a 96-99 bumper).
I'd like to do the wiring up as stock as possible (i.e. install a new factory switch, add all the normal relays, fuses, et...
Topic ID: 12896 • Post ID: 5244507

96 bumper cover on 94 - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
excellent. thanks dude!
where do the fog light mounting brackets connect to? the plastic bumper cover?
I'm thinking if I put this thing on, I'm going to want to put the fog lights in. Wiring them m...
Topic ID: 12701 • Post ID: 5242041

96 bumper cover on 94 - 6G Celicas Forums

EnthusiastJoined May 20, '04From Saskatoon, SK, CanadaCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
Hi all,
I've got a 1994 Celica and I'd like to put a 1996 front bumper cover on it. I think the newer style covers look a lot better.
Are the bumper covers interchangable? Or are the mounting points...
Topic ID: 12701 • Post ID: 5242039
Showing page 1 of 1 (19 total posts)