Home > Members > Tenchi's Topics
← Back to Members
💬 Tenchi's Topics

Tenchi

Member
Topics
10
Vehicles
1

A cure for sticky needles? - 6G Celicas Forums

6th Generation Celica › Interior/Audio/Electrical/Wiring
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 4, '02From South CarolinaCurrentlyOfflineReputation:0(0%)
The indiglo gauges were installed a month ago in the Celica. I got these gauges from Speedhut. At first the RPM needle was getting stuck at idle and the speedometer needle was getting stuck at 0-10m...
10 replies Topic ID: 898

Wooo Wooo!!! - 6G Celicas Forums

6th Generation Celica › General Discussion
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Nov 26, '02CurrentlyOfflineReputation:0(0%)
From the people who brought you the LED washer nozzles, the new trend for rIcE bOyS y0!, the neighbors will love it, it is The Whistling Muffler!!11!?!???!?!?
Can it get worst than this??? Be sure to...
11 replies Topic ID: 801

Anyone know which kits are these? - 6G Celicas Forums

6th Generation Celica › Exterior Styling
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Nov 4, '02From Sydney, AustraliaCurrentlyOfflineReputation:0(0%)
1.
2.
Thank you!
20 replies Topic ID: 598
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Oct 30, '05From MICHIGANCurrentlyOfflineReputation:11(76%)
WTB:
- Stock Fuel Door - Any color, but in good condition (No rust or broken tabs).
- Stock Climate Control - Again in good working condition without peeling face.
- Rear Hatch plastic tabs / screws. ...
2 replies Topic ID: 48525

Code 52 - Knock Sensor - 6G Celicas Forums

6th Generation Celica › Engine/Transmission/Maintenance
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: ModeratorJoined Oct 1, '02From fall river, maCurrentlyOfflineReputation:13(100%)
Just wondering... how tough is it to change this sensor? I have some basic tools with jack stands and a hydrolic jack...
6 replies Topic ID: 32292

Just curious... - 6G Celicas Forums

6th Generation Celica › General Discussion
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: ModeratorJoined Oct 1, '02From fall river, maCurrentlyOfflineReputation:13(100%)
Does toyota have a special tool that fits in those small holes to remove the rear lights instead of taking the whole rear apart? I broke the small corner snap when I removed the rear plastic panel.
I...
5 replies Topic ID: 1866

WTB: Driver's side high beam - 6G Celicas Forums

6th Generation Celica › Buying/Selling
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 1, '04From AlabamaCurrentlyOfflineReputation:0(0%)
As topic say, looking for a driver's side high beam in good condition, no leaks. Mine has a leak and is full of water. It turned the whole thing brown because the water has been there for a long tim...
10 replies Topic ID: 18465

Having problems... - 6G Celicas Forums

6th Generation Celica › General Discussion
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Oct 3, '02From Va Team 6gcCurrentlyOfflineReputation:1(100%)
When I start the car the oil light stays on for a couple of seconds or until I accelerate a little. I checked the oil level and its fine. I changed the oil not too long ago. Actually this has been ...
13 replies Topic ID: 12318

Have you all seen this... - 6G Celicas Forums

6th Generation Celica › General Discussion
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Celica vs. Type R
56k beware!
http://iquebec.ifrance.com/mpgt/Acura-Inte...R/hahahaha.html
lol!!
2 replies Topic ID: 116

Info for JDM Lights - 6G Celicas Forums

6th Generation Celica › Exterior Styling
Started: EnthusiastJoined Nov 20, '02CurrentlyOfflineReputation:1(100%)
Last reply: EnthusiastJoined Sep 27, '02From UKCurrentlyOfflineReputation:1(100%)
Hey all,
I'm new to this site, and I love it! Lots of great info that I have been searching for a while. While browsing, I checked out the information page listed on the home page and found the JDM ...
13 replies Topic ID: 110
Showing page 1 of 1 (10 total topics started)