Ok, so I got this off of a member here for 120 (105 shipping and 15 product) because it was just sitting in his garage (thanks Kdash) and the only thing is that its dirty and has a crack in it.

Any suggestions on fixing? Im going to use fiberglass and bondo for sure, I'm just wondering how I should go about it because of its place.




edit: fixed

This post has been edited by Andason: May 17, 2004 - 11:45 AM

first of all, dont put it on your car, cause the invader type rear bumper is fugly...

but seriosly I have no knowledge of fiberglass at all

-Chrobis+May 17, 2004 - 4:46 PM

cut the opening and put in fiberglass mat, then fiberglass resin(hardener) over it. put as many coats of fiberglss over it as u want, then bondo then sand and prine and ya done,, very easy but if you dont want it il be glad to pay u 15 bux for it lol

yea looks to be a pretty easy fix....good find...shame the shipping was so much

unless you have the piece thats missing it's gonna be a little tricky to get perfect. i would suggest making a mold of the same spot from another ibumper like that then make the piece you need to fill the hole from the mold out of fiberglass and then fiberglass it in place. thats the easiest way i could think of but you need access to another invader rear to do it.

-nicksceli+May 17, 2004 - 4:42 PM

I dont think there's a way to reverse it.

i couldnt think of a that you could reverse it. if theres a way please post it. it would come in hand for a few little projects i want to do.