just got my window control module and im ready to install. but i cannot seem to plan out how i am gonna get it from the door to the car. i can either go through the plug or drill a new hole. normally i would go through the plug, but the problem is, i gotta get 4 wires in+16GA wire for future system install. anyone have any bright ideas?

i suggest pulling the wire through with a coat hanger (going through the little booty where the other wires are run)

or you can take a screwdriver and pry the seal of the booty on each end leaving you open spots to run wires through, then so its not a sight for sore eyes wrap it all up in electrical tape when your done.

There's a post on this about a week back.. 2 pages long

I just did it for my locks, I wrapped the hot/ground wires together and they had enough stiffness to make it through.

Takes a few tries, just make sure you go from door to car.

When I wired in my new mirrors I had to run wires that were missing.(to control the folding motor)
I used a coat hanger with the wire taped to it to pull them through the door rubber plug, 90% of my install time was just running the wires. I was very happy with the final result as things look stock with no new holes or out of place wires.

yeah it takes a lil, I did it both for my windows, an locks.. if someone didnt already say, take out your speakers.. that will even help for more room to work with.