rjbibeau

#1

all right all of you 5sfte people out there i was wondering how you guys mounted your 2 bar map sensor either from an mr2 or a celica i have both sensors and the all trac one is like tack welded to the mount and the mr2 has nothing attached to it. i was wondering if you guys made a special bracket for it or what

presure2

#2

just use the stock bracket, attaced right where yours is now. >>

---

Former Team 5SFTE pro member ;)13.6@108MPH, 5SFTE Powered

Supersprynt

#3

Thats what I did, it just inclips you dont even have to take it off the firewall.

---

MyFlickrMyeBay_Perpetual Aperture_

rjbibeau

#4

but the harness is on the oppsoiste side n the wires aren't long enough...

presure2

#5

??? you should be able to just unplug yours, and plug the new one in..

---

Former Team 5SFTE pro member ;)13.6@108MPH, 5SFTE Powered

1bwilson

#6

I put mine on upside down.

---

Member of Team 5sfTe

Chrobis

#7

the map sensor from an MR2 is different then one from an alltrac.... they may be mechanically the same but the way its mounted is completly different...

Im guessing you have the Mr2 one because my shop tried that one and was gona ghetto rig something to install it... but the alltrac one is lined up and will attach to your stock bracket.

Therefor you will need to just figure something out if you have the mr2 one.

rjbibeau

#8

i have both... and by the way the sensor should be mounted upright to let the moisture out i think.

Chrobis

#9

well if you have an alltrac one, remove it from the alltrac mount and put it on your current mount.

rjbibeau

#10

the mount is like tack weleded to the sensor or something it doesn't slip off like the stock 5s one does and the mr2 2 bar one.

Chrobis

#11

I ordered a brand new alltrac map sensor, and it came with that bracket, I kinda had to break a little plastic on the map sensor to get it off the bracket, which I tried my best not to do. If you peel back the sticker you will see how it is held on and will be able to work at it better.