Project ST204.5 99.88946% complete...
3S-GTE Connector E6 (A)
# Color Abbr. Description Comments
1 W-R BATT Battery
2 B ELS Idle Up Diode (Taillight, Defogger)
3 NOT USED
4 G-W STP Stop light Signal
5 G-W W Check Engine Light
6 L-R FPR Fuel Flow Increase
7 L-Y PSCT To Power Steering ECU
8 B PS Power Steering
9 V-W SPD Speedometer
10 B-W A/C To A/C Magnetic Clutch Must be logic inverted to the 1MZ ECU
11 R STA Starter Signal (Clutch SW) C9 Activated
12 B-Y +B Keyed +12V
13 B-Y +B1 Keyed +12V
14 G-R FC Fuel Cut
15 G- Y ABS To ABS ECU
5SFE Connector E6 (B) (M/T)
# Color Abbr. Description Comments
1 B-Y +B1 Keyed +12V
2 W-R BATT Battery
3 V-Y VF To EA1-9, then R-W To Check Conn.
4 G-R FC Fuel Cut
5 B ELS Idle Up Diode (Taillight, Defogger) BGB says P-G
6 NOT USED
7 L-Y PSCT To Power Steering ECU
8 B-Y +B Keyed +12V
9 G-W W Check Engine Light
10 NOT USED
11 B-W A/C To A/C Magnetic Clutch
12 V-W SPD Speedometer, Speed Sensor
13 P-G Unknown, BGB says it doesnt exist
14 B PS Power Steering
3S-GTE Connector E8 (B)
# Color Abbr. Description Comments
1 G- B TVIS Toyota Variable Induction System
2 L -O TPC Turbo Pressure Control
3 W-R IGF Igniter
4 B NE Distributor (Shielded)
5 W G2 Distributor (Shielded)
6 B-R EGR EGR VSV
7 G STJ From Cold Start Injector
8 R-W HT Heater Wire for O2 Sensor
9 G RSC Idle Speed Control Valve
10 R RSO Idle Speed Control Valve
11 W-L #2 Injector #2
12 R-W #1 Injector #1
13 BR EO2 Ground
14 BR E1 Ground (Diagnostic)
15 NOT USED
16 NOT USED
17 R G- Distributor (Shielded)
18 G G1 Distributor (Shielded)
19 NOT USED
20 W IGT Igniter
21 NOT USED
22 NOT USED
23 NOT USED
24 G- Y #4 Injector #4
25 B-W #3 Injector #3
26 BR EO1 Ground
3S-GTE Connector E7 ©
# Color Abbr. Description Comments
1 R-L VC Turbo Pressure Sensor
2 Y-L VS AFM
3 B THA AFM
4 R THW EFI Water Temp Sensor
5 L-B PIM Turbo Pressure Sensor (+ Turbo Meter)
6 B OX O2 Sensor
7 NOT USED
8 R-W VF Data link (VF)
9 BR E2 Ground
10 B-Y THG EGR Temp Sensor
11 W VTA Throttle Position Sensor
12 P IDL Throttle Position Sensor
13 B KNK Knock Sensor
14 P-L TE2 Data link (TE2)
15 B TE1 Data link (TE1)
3S-GTE Junction Connector EA1
# Color Description Comments
1
2 G-R FC
3 L-O Engine Compartment Temp sens. to CF ECU N/A
4 L Engine Compartment Temp sens. to CF ECU N/A
5 L-Y From cooling fan ECU to Combo Meter N/A
6
7 W-B From STA Relay to Theft ECU
8 R-G From engine hood courtesy to Theft ECU
9 R-W V-Y Check connector to ECU VF1 5S-FE
10 V-W (V) From Speed Sensor to SPD CC ECU Hook to Speed sensor
11 L-B From Turbo Pressure sensor to Boost gauge
12 L-B Fuel Pump to check connector
3S-GTE Junction Connector EA3
# Color Description Comments
1 W From TC of CC ECU to TC of Check Conn. ABS, PS, SRS ECU
2 Y From TS of ABS ECU to TS of Check Conn.
3 W-B From Temp Gauge to Engine Manifold Ground 1MZFE: BR
4 Y From IG2 to Alternator
5 B From Igniter to Tachometer (if you use the V6 tach) IMPORTANT: to 1MZFE E8 (B) pin 27
6 Y-G Water Temp Sender to Water Temp Gauge Check Ohms of 1M unit
7 Y-B From Oil Press SW to Oil Warning Light
8 R From ST2 to Sta relay (Also CSI and time SW) 5SFE: R-W
9 BR From A/C Idle up VSV to VSV of A/C Amp Gnd. 5SFE: BR-B
10 Y-L From PRS of A/C Amp to A/C Idle up VSV
11 R Engine Oil Level Sensor to Low Oil Light Not Used, 5SFE: No Wire
12 R-Y From SRS Assembly to DLC AB
13 R-B From BK/U SW to BK/U Lights
14 BR Intake Temp Sensor To Ground 5S-FE
15 Y From Intake Temp Sensor to THA of ECU 5S-FE
16 B-W A/C Magnetic clutch to A/C Mag. Clutch Relay
17 W-R From ALT Sensing Fuse to S of Alternator
18 P From IDL of CC ECU to IDL of ECU For Cruise Control
3S-GTE Junction Connector EB1
# Color Description Comments
1 B-R From ECU IG Fuse to Ignition Coil
2 B-Y From Circuit Opening Relay to +B of DLC
3 G-W (B-R) Cooling Fan Relay to Cooling Fan ECU 3S-GTE
4 B-R From ECU IG Fuse to Noise filter
5 B-R From ECU IG Fuse to Igniter
6 L-B Cooling Fan Motor to Cooling Fan Relay 3S-GTE
7 B-Y From ECU IG Fuse to IG of Alternator Also BK/U SW
8 L-B From Circuit Opening Relay to FP of DLC
This might also help.