I've searched til my head hurts and I can't find the answer to my question...


will the axles from an ST185 All Trac work in an MR2T transmission with LSD?

Yota, I do not know about the alltrac axels. Here is the thread where Ray (Kuya1284) talks about the axels you need and the fact that he used 88-91 camry V6 outter half-shafts:

MR2T Transmission Conversion

In sum:

The inner half-shafts need to be MR2T axles (LSD or non-LSD type, depending if you decide to install the LSD)...

With my application, I'm using 88-91 V6 Camry outter half-shafts to make this work... you cannot use the full MR2T axles because

1. They're too short
2. The outter shaft will not connect to your hub (as I understand it)

You should be able to find these on car-part.com for less than $100-$200.

Hope it helps.

From what I hear ( dont know 100% since mines not installed) the Alltrac outter 1/2s will work same as the Camry V6 1/2s.

J-

Thanks man. That clarifies my confusion.