Ok.. well I had an older post, saying that I replaced my front brakes, and sence then I have been having a few problems. A: I broke off a stud so im running on 4 lugs. Which hasnt been at all a problem in the past. B: When im driving above 50ish My stearing wheels is gettign intermitin shaking. I know I already need an alignment, but didnt want to do that if im going to need to replace barings ro somthing.
I checked the tire pressure and im all good. I need to still finish the rear brakes, cause i have not replaced them yet. The tire ware is normal, so im a little bit lost.
I didnt get this shake before the brake change, and after i have gone back twice and made sure everything was on tight and right.
It feels like my wheel needs to be balanced again like the last time i did, but why would that change from just pulling it off and putting it back on?
Any help or comments are welcome
Thanks
Doug
This post has been edited by Digndoug: Aug 15, 2005 - 11:35 AM
I checked the tire pressure and im all good. I need to still finish the rear brakes, cause i have not replaced them yet. The tire ware is normal, so im a little bit lost.
I didnt get this shake before the brake change, and after i have gone back twice and made sure everything was on tight and right.
It feels like my wheel needs to be balanced again like the last time i did, but why would that change from just pulling it off and putting it back on?
Any help or comments are welcome
Thanks
Doug
This post has been edited by Digndoug: Aug 15, 2005 - 11:35 AM