I can't figure out how to remove this gear, the chilton's and service manual just says use a puller. I have a 2 arm puller but the arms can't fit behind the rear sproket, and it seems like if it could it would bend it. Any suggestions?
crankshaft timing gear - 6G Celicas Forums
I thought it showed using two screwdrivers on either end to pop it off? I will check tonight...
TJ
TJ
I used a large flat screwdriver. Wedged it in the back, and twisted, then I pried on the other side, then the other,,, you get the picture. Just put a little muscle into it.
ok cool i was just worried about messing it up, thanks.
it's cast iron... you're not going to mess it up unless you use a torch. >
>
>
you need to use two large screwdrivers ....one on ether side and pry it off easy......i cracked mine and need a new one.....
i may go for the 18% UNDERDRIVE
i may go for the 18% UNDERDRIVE
312whp with more to come....