Okay, I have a Weapon-R header. It's a 4-2-1. Stainless steel, blah blah blah. I need to know how to connect the main part of the header where the 4 tubes go into the 2 tubes which later go into the 1 that goes to the exhaust. I tried some WD-40 to make the tubes go in but no good. This thing's a bitch to get in. Can someone tell me the best/easiest way to do this? The pipes are a very tight fit. Thanks.




This post has been edited by JoKeRkId613: Oct 29, 2005 - 8:45 AM

weapon R made headers for our celi???? or was it for another car and ya did a lil work for it to fit our celi?

Yeah, it's for my brother's tC. I guess I'll end up taking it to an exhaust shop. I've tried banging on the top of the thing with a rubber hammer and nothing. This thing's pissing me off already. I don't have patience. Lol. I was real hyped because I thought it was going to be a smooth install. Thanks.

This post has been edited by JoKeRkId613: Oct 29, 2005 - 1:26 PM

tried taking it to an exhaust shop to see if you can get it welded together or something?

If you really want to do it yourself, and not take it to an exhaust shop, you can cut a tiny slit on each of the two pipes coming down from the exhaust outlets. These two slits should allow you to compress the ends of the pipe just enough to slide then into the next ones. You better off taking it to an exhaust shop though, unless there ones like I've got around here, I hate them.