how are u all? well i had my clutch replaced yesterday i went to pick the car up as i was driveing off down the road i looked at the dash board and bam there it was the abs light was on >> so this moarning i had a qwick look over the car i had the hood up and normaly when i turn the ignition on u here the abs pump kick in but nothing apart from i could here the reley box clicking away. Any idea's people?

Thanx Craig

-Craig+Nov 2, 2005 - 8:26 AM

Read the codes buddy, and it should tell you what sensor the monkeys who fitted your clutch have broken.

my abs light is on as well but because i replaced my bad gt hub with a st hub. obviously the gt version has abs and the st does not. but as long as i hear no noise, i am happy.

-LewFX+Nov 2, 2005 - 11:53 AM

Unfortunately, it's a MOT failure in the UK.

only problem is m8 ive got an apexi ecu m8 and ive tried to look for error codes before but it wont show them >> the cars going back to the place i had the clutch done on saturday so will have to see wot they say if worst comes to worst im gonna have to take the bulb out >>

craig

This post has been edited by Craig: Nov 3, 2005 - 5:52 AM

I bet they knocked your speed sensor loose or forgot to connect it. I think it is down by the flywheel been a while since I looked. Even if they broke it it should be fairly cheap I think.

-Craig+Nov 3, 2005 - 5:51 AM

ABS ECU is a totally different system to the Engine ECU.

Read your ABS codes.

how do i check thos m8 the same way u check the engine codes? Tc and E1 terminals?

thanx craig

-Craig+Nov 3, 2005 - 11:48 AM
94-95
ignition in the ON position,
bridge E1 & TC in the diagnostics box, just like checking codes, read the code from the ABS light
codes 31-34 are the sensors @ each wheel.

31 Malfunction of right front wheel speed sensor signal. Check
speed sensor, sensor rotor, wiring harness and connector

32 Malfunction of left front wheel speed sensor signal. Check
speed sensor, sensor rotor, wiring harness and connector

33 Malfunction of right rear wheel speed sensor signal. Check
speed sensor, sensor rotor, wiring harness and connector

34 Malfunction of left rear wheel speed sensor signal. Check
speed sensor, sensor rotor, wiring harness, and connector

This link was most useful when I was going through my ABS hell.
http://www.forparts.com/ICabstoycorolla03.01.htm

well i checked for codes on the abs last night and the light did not flash it just stays on constant. any idea's peeps?

thanx again craig

-Craig+Nov 4, 2005 - 4:02 AM

You bridged TC and E1, turned the ignition on and got no codes? But the ABS light is on?

WTF?

If you bridge correctly and have no codes, the light should flash rapidly. I suspect it wasn't a good bridge.

Did you remember to pull the short pin as described in the link I posted?

ya but i did'nt do it like it said in that pick so im gonna try it again when i get in wot i did was with the ignition off pulled the fuse out bridged the connections then turned the ignition on like i said it did'nt do nothing just stayed on constantly but ive just been going over that web site and it says with the ignition on pull fuse and then bridge the connections. Also another thing m8 before i had my clutch done i use to here the abs unit kick in when i turned the ignition on but now all i can hear when i turn the ignition on is the reley box clicking its ass off.


thanx craig

Yeah, pretty sure the clutch monkies have killed it for you. >>