I was just wondering how the TWM shifter fits into the stock shifter.

How do you remove the old shifter because sometimes there is 4 bolt on top holding the rod in on mine there isnt it looks like a solid unit.

There are two small clipped in pieces facing door to door one in the front of the rod one in the back.

I should have the shifter soon i am just nervous >>

please help!!

wait till you get the shifter directions with pictures are in the box and easy to follow

check the sticky in the interior forum. There is a pdf manual for the TWM SS in there in the 7th gen SS install post, I am hosting it. It has pics and all the instructions you will need.

Thanks guys. I should be getting one soon too.

its an easy install if u got the tools, took me less than an hour to install my 7th gen.

I've got a few steps done on my TWM Shortshifter install, and all is going well so far. I am ready to undo the four 12mm bolts that hold the shifter assembly down. I don't have the right socket accessories at the moment, but here is what I think I am missing:

1) 6-inch extension (I only have a 3 inch right now - using a 3/8" drive ratchet)
2) universal joint (so that I can have flexible angle with ratchet)

Please confirm if this is sufficient. Thanks!

>

i only used a 6 inch extension... it worked fine for me

make sure to put the spacers in underneath the shifter assembly... i didnt do that thinking that it wasnt necessary and found out the hard way when it felt like i had rocks in my shifter

>

Looks like you have the 7th Gen shifter, from your profile. I purchased the one for the 6th Gen, and it does not need or come with the spacers...lucky me. But thanks for the advice on the extension.