hello all

was doing some browsing on exterior upgrades - and wanted to know if the ST202 C-One Front Bumper would be a direct fit with a ST205 Carbon Hood





I am assuming it should - but just wanted to see if anyone knew for sure -

I apologize if this has already been asked in the past - but I don't recall

the ST202 CF Hood - doesn't look as good as the ST205

ST202 below



reason why i ask is that the ST202 looks like one of the scoops on the side is poping down and the other one is up - where as the ST205 both are up -

- i will be installing the Tein EDFC later down the road - and just need to make sure if the ST202 has hood clearance for it - just in case the ST205 hood does not fit the ST202 Bumper

This post has been edited by celicarus: Dec 12, 2005 - 9:29 PM

The C-One hood for the ST202 has both of the vents popping up just like the one for the ST205 but this particular picture distorts it a little.

thanks thats what i needed to know - and i also was browsing and came upon a japanese site - that had an ST202 C One bumper with a ST205 hood - so i answered my own question -

just dont buy body stuff from bulletproof. bad experience with them...took a half year get part, it was protected with one piece of bubble wrap...not even wrapped around the body piece at least. Therefore, it was damaged while in transit naturally. took a half year to resolve and get money back.

yeah i know better than to buy from them - i was just using their pictures as reference - thanks though

The C-one ST202 bumper may not be used with ST205 hood. THe reason is the ST205 hood has a front slope higher than ST202 bumper, then if you have ST205 hood and ST202 bumper, there will be a gap between bumper and hood (I am sure it 's look not so nice).

yep! attention! if you mix up the parts (202/205) it will look dull

like this one: