Topic sums it up pretty well. My speedo jumps sporadically and eventually dies at zero, bouncing up sporadically. Whenever I had problems with this before it was always electricity problems screwing up the voltage readings from the Hall effect sensors. No dice, I tested it thourougly; my electrical system is running strong.
My next stop is the vehicle speed sensor. On my CRX it's right over the transmission housing, but I can't seem to find it on this 7A-FE. Is Toyota hiding it or am I just looking right past it?
Edit I threw a solid CEL today! I the car was slow to start, and then after about 10 minutes of driving i threw a solid CEL (but no limp mode). Where do I jump to pull the CEL and is there a directory of CEL definitions anywhere around?
This post has been edited by [Freemantle]: Jan 16, 2006 - 2:49 PM
My next stop is the vehicle speed sensor. On my CRX it's right over the transmission housing, but I can't seem to find it on this 7A-FE. Is Toyota hiding it or am I just looking right past it?
Edit I threw a solid CEL today! I the car was slow to start, and then after about 10 minutes of driving i threw a solid CEL (but no limp mode). Where do I jump to pull the CEL and is there a directory of CEL definitions anywhere around?
This post has been edited by [Freemantle]: Jan 16, 2006 - 2:49 PM
1995 Celica ST - Riceball grocery getter. I saved her from Neons, 19" rims and TVs. All-stock save a weld-on muffler (does that count?) and V-AFC.1991 CRX - The hobby car. I say that because I can never seem to get it completely together!