Well I bought a 7th gen Celica shifter off of ebay and put it in today. I took the clip off (the one holding the pin in front of the shifter) and it broke. Does any one know where I can get one. Also I never used the shift mechanism lifters. I could not get my hand in the space and the bolts supplied by the kit were not long enough. This is the best $30 I have spent on my car but I put the lifters in will it make it a smother shift. Thanks in advance for any help.

i drilled a tiny hole through the pin and stuck a small nail through it and bent the nail so it wouldnt come out.

scroll down to batman's second post

BAM ---> http://www.6gc.net/forums/index.php?showtopic=22975&st=20

i didnt put the lifters in at first and the bottom cup rubbed on the floor. so i put the back two in and it was perfect. it took a while because it was hard to get my hand in there. i think i held them in place with pliers

This post has been edited by dlx742: Jan 17, 2006 - 12:19 AM

Can I re-use my stock knob with the 7th gen shifter?

>
yes

That is a good idea about the pin and drilling a holl. As far as i can tell the shifter is not hiting the floor but i will put the spacers in anyways when have time, it can't hurt. thanks for the help.

im new so this may be a dumb question but the 7th gen shifters will work on a 6th gen without modding??

>

Correct