um... I was just wondering... does anybody here have a TWM Short Shifter and use a TRD Leather Wrapped Ball Shift Knob?

When i twist the shift knob onto the thread part of the shifter, it doesn't cover the entire threaded part... it gets really tight by the time it's 3/4 covered... i don't wanna twist it anymore in case i ruin the thread on either part

i dunno.. is something actually not right here or am i just incredibly retarded or something?

here are pics of the knob and it's packaging:

front of packaging


pack of packaging


knob + gear positions sticker


knob beside shifter


This post has been edited by elvasoshexai: Feb 10, 2006 - 8:25 PM

anyone?

I bought that shift knob, but never used it cause it looks weird with the stock boot ring.

maybe the hole in the shift knob isn't deep enough! measure it.

i measured it. i stuck a pen in the knob and it was the same length... when i look inside the knob the thread doesn't go all the way though... there is some empty space at the very inside and near the edge. then in the middle is the thread

nobody has this shift knob?

its just the ball doesn't have enough space on the inside.....there is nothing wrong with it

i have no problem with the fitment of my knob. I have a razro saude knob and it fits fine. its probably the actuall threads on the inside of the trd one.