Ha guys just drove my 94 celica with the new centerforce clutch I installed. Well the clutch pedal doesn't disengage the clutch until the pedal is almost on the floor! So how do I adjust this?

-I see there is a threaded rod on the clutch pedal that I will lengthen but there is only a 1/4" left to lengthen the rod so I don't believe I'll gain much here!



-I'll try bleeding the line even though it was never opened...


-ANy other ideas????


-I am thinking of wellding a little extra metal onto the pushrod that is at the clutch end to get more length to work with....Is this called the master cylinder can't remeber the tech. term.... *I'll do this last if others don't help......

dont weld anything on

1st try a full adjustment. if that dosnt help you, they sell longer push rods for our cars.

read this PDF, it will explain how to adjust it.
http://www.celicatech.com/imagearchive/bgb...nual/clutch.pdf

didnt your centerforce clutch come with a adjustment sheet. i just got my clutch done about 2 weeks ago, and there was a sheet in there for adjustments. Maybe you can call canterforce, and ask them to send you that sheet.

Thanks guys I have that sheet and will look into it tomorrow. First thing I will do is bleed the system. However,

-were do you get a longer pushrod from as this is so far off I am sure I will need one.


-Can you tell me how much longer this different push rod is? Or know someone who could tell me the length of one of the longer ones so I can compare with what I have??? Thanks.....

www.twosrus.com

THanks for all the help guys I was able to screw the rod out on the clutch pedal to make it longer. I only had 1/4" to work with but that gave me a few inches more to use on the clutch pedal. So it looks like the clutch job was a success!!!!!

For all those that are looking for the longer slave cylinder push rod here is the site. They also sell the shifter bushings.
http://www.speed-source.net/

>


hmm i thought people replaced the push rod thats connected to the clutch pedal, and not the one thats on the slave cylinder ?