Authentic HKS intake kit for ST205. Comes with Filter, Aluminum Intake Pipe, and Factory Plastic Turbo-to-Intake Pipe. It came with my clip and have upgraded to a different Air Filter setup. You will need one 4" hose clamp and rubber grommet for the IAT Sensor hole.

Sold As Is. Asking $50+shipping. PM if interested.

-Colin

any chance youd sell me just the factory turbo plastic part, im pretty sure im the only person with a swap on here that doesnt have it damn mr2 clips

edit: also whats the 4" clamp fore? do you mean 3"? the entire thing should only be 3" in diameter

This post has been edited by brianforster: May 30, 2006 - 8:20 PM

Wish i could use it but its not a stock turbo.
Have anything else? im pretty close, you don't happen to have a rear end do you?

Steve

Sorry Steve, I don't have anything else of use to you.

Brian,

If no one else has any interest in it as a whole, I'll sell it to you. The 4" clamp would be used where the filter meets the aluminum tube as in the last picture. The filters outlet is 4" in dia. The Aluminum tube itself goes from 4" to 3". Btw, the turbo housing outlet is actually 2.75" dia. incase you ever decide to make something custom.

-Colin

oh ok, yeah, get back to me on the stock piece, or if whoever decides to buy it doesnt need the stock piece, contact me

Bump.

i just realized i dont think this will fit my car cause this is a 3rd gen intake, im not sure where the afm would hook up since the outlet is bigger, i think