Okay, I installed new kyb gr-2's and some tein s-techs the other day and when i was doing the rears the bolts securing my sway bar to my rear sturts were seized hard, and i rounded out the allan key slot and basically screwed myself. I decided to just cut my sway bar end links in half.

What are my options now? should i look for used ones or is there a place i can get new ones for a decent price, or should i perhaps look at upgrading my entire sway bar??? I'd prefer to go the cheapest route obviously.

Thanks,
Shawn

(on a side note, i hear a very strange clunking noise when i turn my wheels 100% to the right of left, as if something was catching. It's coming from the front.)

This post has been edited by Tech9ine: Jun 24, 2006 - 1:39 PM

its because you dont have any sway end links in the rear!!! go buy some and put them on, your car is not safe to drive w/o them. did you change or grease the strut bearings?

This post has been edited by LewFX: Jun 24, 2006 - 1:28 PM

strut bearing??? would that be the disc on the top of the strut assembly which gets covered by the top cap? if so, then yes i greased it up something fierce. But if its something else... then no, i did not grease it.

This post has been edited by Tech9ine: Jun 24, 2006 - 2:08 PM

you would need to completely cut the links off then install new ones.