I ordered a TRD quickshifter and im getting ready to take out the old shifter. but i dont have the right socket to unscrew the shifter. so what size socket fits?
- 180k and still running strong"Yes...yes I do have a myspace..."
A metric size. So either 10/12/14mm would do the trick.
BTW where did you order your Shifter?
This post has been edited by Kadett: Jan 1, 2007 - 4:28 PM
JDM Powerplant installed, BPU coming very soon!
looks like a 14mm, but hard to tell from the pic, just remember our cars use metric so 10,12,14, etc is your best bet
sweet, thanks guys ill go pick that up tomorrow.
Kadett, i got mine at TRDSource --->
TRD Sourceanother place i found was Sparkstoyota --->
Sparkstoyota
- 180k and still running strong"Yes...yes I do have a myspace..."
from memory its the same size as the socket used to remove the two blots in the armrest, which again from memory is a 14mm socket.
