Daftboy

#1

The rims I ordered where 17*7 with a 42 offset...what should I buy to get them flush with the car...I want the tire at the fender

---

--------------------------------私は銀行に漂う,TRDInspired

supradog1

#2

you will need 4, 25mm spacers to get it flush... it will look realy nice, i had same spacers with my old 17x7 wheels that were +42 offset...

This post has been edited by supradog1: May 1, 2007 - 11:11 AM

Daftboy

#3

Thank you very much ...Which brand did you use?

This post has been edited by Daftboy: May 1, 2007 - 11:23 AM

---

--------------------------------私は銀行に漂う,TRDInspired

supradog1

#4

ichiba spacers are pritty good choice but h&r or eibach are the best on the market...

Daftboy

#5

H&R does not have a 25mm only a 20mm....Ill keep looking.....EDIT...foudn them in 25mm...=]

This post has been edited by Daftboy: May 1, 2007 - 11:36 AM

---

--------------------------------私は銀行に漂う,TRDInspired

Daftboy

#6

OK well I was looking at my rims now that there on and all my front don't look like they need much of anything maybe 5mm or so but the rear there is a huge gap....should i just measure the space with aruler and go like that?

---

--------------------------------私は銀行に漂う,TRDInspired

supradog1

#7

>

QUOTE(Daftboy @ May 23, 2007 - 4:02 PM) [snapback]560938[/snapback]

>
OK well I was looking at my rims now that there on and all my front don't look like they need much of anything maybe 5mm or so but the rear there is a huge gap....should i just measure the space with aruler and go like that?

yes that works fine, but remember to subtract 2mm or so from the mesurement for clearence...