Well as stated I was wondering how to take out my CC....I know you take out all of the screws then there is a control on left drivers side that you DC (controls the cold/warm air knob). But then there are some more tubes leading out the back through a white caseing and into my engine bay. Do I need to take all of that apart? If so what is the best way too do this thanks in advance.

This post has been edited by Daftboy: May 8, 2007 - 3:23 PM

how-to

<-----LAME

Thanks =]

nvm

This post has been edited by DSToyo: May 9, 2007 - 12:31 PM

Yea I pulled it out in about 2 min. I jsut was not sure if I need to take all the wires out...lol

dont worry i was the same way when i first tired to take them out