Hi Coomer!

Have you recieved your 4age 20v sl yet?

What are your plans for it?

Hi,
I got my second engine a while ago, and since then we've just been waiting for parts to come in so that we can replace some stuff on the engine before it's in the car.

I've got the timing belt, water pump, front and rear main seals, distributor rotor, spark plugs, spark plug wires, a couple parts for the idler pulley, and a JUN flywheel, but I'm still waiting on my distributor cap and idler pulley and tensioner and clutch.

As far as engine modifications go, right now it's going to be pretty much stock, except for an aftermarket clutch and my JUN flywheel, but I plan to fabricate a cold air intake for the engine once it's in. >>

how much hp will it put out when its done?

Well, typically most silver top 4A-GE engines put out approximately 140-150 horsepower at 7400 rpm at the flywheel, so I'm hoping for similar numbers. I'm also putting in a lightweight flywheel that weighs half as much as stock though, so the engine will rev quicker and be a bit faster though. >>

how much did that flywheel set you back?

I got it for $290 shipped on eBay. It's a brand new genuine JUN flywheel made for the AE86 Corolla that's made out of chromoly steel and weighs just 9 lbs. >> It'll work fine for my car because I'm using a clutch that's made to work with the AE86 Corolla. >>

All sounds very very nice.

Remember, that there very tame. Very tame. But once upgraded, there are in the black top world.

Good luck >>