Over 1M Posts • 84K Topics • 9K Authors

Home > Topic #58736

FS: JDM blinker & headlight stalks - 6G Celicas Forums

Topic #58736 15 posts Started by GriffGirl
GriffGirl
#1
This came with some fogs I got, but I'm not going to use it, so it only seems fair to offer it up to you guys! Make offer.

Here's some pix, practical and alluring! Note that the blinker stalk and the headlights/foglight stalk are reversed from the USDM stalks. I'm just too OCD to be able to adapt to this Left Hand Side of the Bed™ way of life.


>>^Full frontal.>>


>>^Left stalk, aka The Wiper & Turn Signal>>


>>^The right stalk, aka low beam, high beam and fog light controls. Note the fog light is controlled with a separate rotating switch similarly to the way the intermittent wiper speed is controlled.>>


>>^Original JDM wiring harness action. Wires and plugs in very good condition with no evidence of corrosion.>>


>>^Back side of the unit just for good measure. Sorry it's a little blurry. >>

This post has been edited by GriffGirl: Jul 29, 2008 - 12:14 PM
BloodyStupidDave...
#2
>
QUOTE (GriffGirl @ May 23, 2008 - 10:03 PM) *
>This came with some fogs I got, but I'm not going to use it, so it only seems fair to offer it up to you guys! I'm looking for best offer but would be even happier to trade them with someone who has a stock push-button fog switch.


Wasn't someone on the forums looking to change their stock UK/US setup for a JDM setup just last week? Also, can you post the part numbers for the left and for the right stalk (even better if you can post the numbers for the US versions also)?
DaveyItems for sale
GriffGirl
#3
I'm all for that, but I haven't got the slightest clue as to how to locate the PN for the USDM switch. The JDM stalks I have have lots of numbers on it, I believe the turn signal is a different PN than the light stalk, as is the center part they connect to.
GriffGirl
#5
^ Yuppers!

Bump! Still for sale!
BloodyStupidDave...
#6
>
QUOTE (GriffGirl @ May 23, 2008 - 11:09 PM) *
>I haven't got the slightest clue as to how to locate the PN for the USDM switch.


They should have 10 digit number probably starting 84310, 84140, 84112 or 84650. However the UK ones have a six digit part number instead:

Left (Lights and turn - inc fog): 17A089
Right (Wipers/washers - inc. 4 position intermittent): 17A164 LH
DaveyItems for sale
njccmd2002
#7
ouch, but I hope it helps


http://cgi.ebay.com/ebaymotors/JDM-Toyota-...sspagenameZWDVW


>
QUOTE (njccmd2002 @ May 28, 2008 - 6:34 PM) *
>ouch, but I hope it helps


http://cgi.ebay.com/ebaymotors/JDM-Toyota-...sspagenameZWDVW



and another one

http://cgi.ebay.com/ebaymotors/TOYOTA-FOG-...sspagenameZWDVW

Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
GriffGirl
#8
I saw those, thanks for lookin' out. I thought Toyota made round ones... I'm holding out for a round one. I may go to a junk yard and get a non-Toyota one, so it's round. I want to put it in that little circle on the left driver's heat vent.

Bump-a-Roni, the San Francisco treat.
BloodyStupidDave...
#9
>
QUOTE (GriffGirl @ May 30, 2008 - 8:40 PM) *
>I saw those, thanks for lookin' out. I thought Toyota made round ones... I'm holding out for a round one. I may go to a junk yard and get a non-Toyota one, so it's round. I want to put it in that little circle on the left driver's heat vent.

Bump-a-Roni, the San Francisco treat.


The part numbers are:

84165-20040
84165-20060

The first part number is for the basic switch, which is the easiest to work with if you are going to mod. The second part number is for the smart switch - it has a few extra wires and some logic to ensure that the fogs only work with the correct combinations of other lights (ie you have to have your lights on but not your full beams). They look identical when installed. They are pretty hard to find in the US I understand - I'll keep a lookout at my local scrap yards for you.

UKDM / EDM spec foglights howto

This post has been edited by BloodyStupidDavey: May 30, 2008 - 2:52 PM
DaveyItems for sale
GriffGirl
#10
Bump. I still have this if anyone's interested.
pipes
#11
hey how muched shipped to 02136 i also am still parting out my gt anything you may need? il give it to you if i still have it let me know
FunkySR
#12
are you sure the turn stalk is not on the right side??
pipes
#13
>
QUOTE (FunkySR @ Jul 4, 2008 - 12:24 PM) *
>are you sure the turn stalk is not on the right side??



they are on the right side just like in europe and japan
← Back to Topics