uhmm recently my car is down due to the fact that my caliper came off

and both the screws hold the caliper are gone

does anyone know the part number? its the kinda long screw... if that helps

i tried asking toyota but thy keep giving me the dam tiny ones and thier huge o.o

Its called a caliper guide bolt. Im having trouble finding a part number...they should have it. I had the same problem but reverse. I was looking for the little ones, not the long ones, and they were able to look it up. I also went in with the bolt in my other car.

yea the little ones they keep giving me after countless times.

so im just trying to find the direct part number to shut them up

alright, try this....
Slide pin main - 4771506030 06020
sub slide pin (has bushing at end) 4771506020

This dealership gave me these part numbers....i think they are the same thing. They really need to keep things universal as far as what to call things....gets confusing after a while. They should be able to pull up the part number and show you the IPB and you can point it out to them if its not right, but appears on the IPB. Good luck.

alright, try this....
Slide pin main - 4771506030
sub slide pin (has bushing at end) 4771506020

This dealership gave me these part numbers....i think they are the same thing. They really need to keep things universal as far as what to call things....gets confusing after a while. They should be able to pull up the part number and show you the IPB and you can point it out to them if its not right, but appears on the IPB. Good luck.

hmm well i just got one of them today o.O

took a lot of yelling xD

the part number on these were 9010508164

now i just gotta wait till tomorrow

I've just lost the bolt from mine. Front left wheel, when looking at it, caliper is on left of the disc, and the bottom bolt is missing.. does anyone know if this is the long or short one? Reading from this, I'm a bit confused..

is it able to where you can slide the caliper? if it is.. i have the part number listed

>

dunno about sliding it, but i could lift it from the bottom, the top still seemed to be intact

ehh just taking an guess.. i think you need the same bolt i was looking for.

>

someone from celica club said you can use a standard bolt as long as its the same width, length etc...have you heard this?

yea i have, but im rather lazy to go look for it

>
bolts have different grades depending on their hardness, just ask someone at a home improvement store and they can point ya in the right direction

>

that's what caused them to fall out in the first place.

>

how does that relate

>
:: HEY.....whats that noise?? I unno Im too Lazy to look rite now im sure its nothing::

>

oook that was random, kuz there was no noise till they were missing?

This post has been edited by hongkongnerdboy: Jun 12, 2008 - 12:55 AM