Can some one point me in the right direction on the 3rd gen wiring harness convention. I hear its not to hard but i cant find what exactly you have to do.

anyone??

From what I hear, its all plug and play. You just have to rewire the Circuit Opening Relay (look at the 5sfe wiring diagrams).
You also have to either "flip" the harness, or cut a hole in your firewall, because the harness is for a rhd car.

All very easy stuff to do.

you need to wire in the fuel pump relay and the IC relay. Both are wired from EA1 and not too difficult overall. Also you need to switch a pin over from one of the interior plugs (for clutch start switch).

Or if you are uncomfortable, contact Dr Tweak.

Thanks!! very helpful info. I'm now getting the old engine out and ready to put every thing in. I found out the hard way that the turbo manifold does not fit from the st185 .