I'm new here but have been on Alltrac.net for a while. I also know darthripley here on your site if you need references.
I'm in Austin, TX and have a 93 ST-185 (All-Trac).

I just bought these in February but I have had zero time to put them on or finish the adjustments needed to make them fit on my st185.
I figured these might be of interest over here...

I have the front ST-205 ABS hubs with the dust shields, All four calipers with semi used pads, all of the hardware, and all 4 rotors. You can have it all for $700 shipped FedEx in the Lower 48.

I bought some rust off stuff for the hubs and only soaked one of the front rotors, that stuff works really well, if you want to clean the rotors up more. I also degreased and scrubbed down the calipers. I started stripping the old red paint off and only got one rear one done so far.

I need to address my dripping rear diff and get a new charge cooler - it's more pressing right now than the brakes.

These are in good shape and there is good life left on the pads and rotors. They also have 2 uncut lines!

Nice to meet everyone, I'll post up my car and more info next.

Pics:




Hardware:


More pics here:
Pics of Hubs more pics
http://s369.photobucket.com/albums/oo139/alltrac93/calipers/

bump now on ebay

http://cgi.ebay.com/ebaymotors/ST-205-GT4-...sQ5fAccessories

can you show me measurement of the rotors right now? with a micrometer?

I don't have a micrometer but I'll pick one up tomorrow and get some measurements. I could use one....

dibs!!!! im serious! can it be bought directly from you so i dont ahve to mess with ebay?

My neighbor had a micrometer but it's a manual sliding one.
Here are the approx measurements for rotor thickness.

Front: 29.5 mm
Rear: 15.75 mm

**Sold** Pending payment...pls lv open until then.

For those asking, I joined here primarily to keep track of the local Celica Meets here in Texas (Austin).

I also plan on doing a full 3rd Gen 3s-gte swap into my 2nd gen ST185.

Nice to meet you all.