Hey guys,
I'm changing my rear engine mount on my 94 st celica with automatic tranny.
I have manage to take the old one out but putting the new one back in true the 2 crossmembers is giving me trouble.
does someone has any suggestions?
thx!!!
lift the tranny in the rear to give space. that helps. you have to release the front support
Learned a lot in 10 years...I hardly log in anymore, last loginToday Sept 6 2019, and I was forced just to clarify a post. LOLIf you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in2grfe Swapped...Why I chose the 2GR, before you ask read here...A great civilization is not conquered from without until it has destroyed itself from within.@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.
I just loosened the bolts of the whole crossmember and jacked up the tranny to give it room to move in. Then the trick is to play with it to get it in.
94 Celica GT|Toyota OEM Japan|Toyota Racing Development|Tom's|Competition Clutch|5Zigen|Apexi||Laille/Beatrush|Magnecor|Denso|Royal Purple|Optima|PIAA|PW JDM|Megan Racing|Nitto||Work|Greddy|Samco|Project Mu|H&R|Gates|Moog|Rota|Yokohama|Epman|1320|Upgr804 Celica GT|Toyota OEM Japan|Toyota Racing Development|Tein|BC Racing|Greddy|89 Supra (Sold)90 Supra (Sold)
yup, you just have to rotate the motor a little to gain a little clearance to slide into place.
Former Team 5SFTE pro member ;)13.6@108MPH, 5SFTE Powered
Hey guys,
Thx very much for your tips! I had to strugle a bit, but it finally went in.
In my case I had to unjack the tranny to have enough clearance.
But I have strugle the hole weekend with this.......my entire body is in pain now hahahahah
Thx again guys!
