My header needs to be replaced. I tried ordering the OBX headers off 2kracing.com but they don't have them and won't be getting them so I'm SOL.

I found these....
http://cgi.ebay.com/ebaymotors/OBX-Exhaust...%3A1|240%3A1318

Obviously they're for the 5s-fe Camry and I know they'll hook up to the block just fine but what about on the other end?

I also looked on the forums here to try to get the info but 90% of the talk was for the ST - Corolla compatibility.

I have a stock exhaust setup now so my main question is if I buy these will they just hook up to the rest of my exhaust, or will I need to make a minor mod?
-Thanks

A lot of people have this header. Myself included.

They replace the exhaust manifold and primary cat. They bolt right up to the flex pipe section. no problems at all with installation.

Edit: there's only 1 header in our car.

This post has been edited by jimmykay: May 22, 2009 - 10:48 AM

idk.. this is bugging me too lol

i like this one

This post has been edited by terbear4god4life: May 22, 2009 - 10:49 AM

my bro has a 95 camry 5 speed 5sfe. he has some obx headers on them. bought them on ebay for $220. they are good quality and you cant go wrong with them.

Thanks for the info guys.

But no one knows whether this will fit properly?

Anyone have any diagrams they have bookmarked or something? I've been looking online for days now and haven't found anything.

It looks like its for a 5sfe motor because of the 2.2l but I am not sure if the Camry used the 5sfe until 01, if thats the case the manifold will bolt right up. problem is will it bolt down to your exhaust piping more than likely no, you may have to repipe.