Hey, this and my hydro clutch is the only thing stopping me from pulling out the motor. How do i get these two lines out and how should i disconnect the clutch line. Thanks for the help in advance! Thanks
Need help with shifter link and hydro clutch removal. - 6G Celicas Forums
use pliers to pull the tab out
that seems simple enough, thanks enderswift! i cant believe i didn't try doing that. What is the best way to take off the clutch line to remove the tranny without loosing all of the fluid to the ground? thanks!
edit: i guess i can just take off the whole assembly including all of the lines in once peice
This post has been edited by Projek_01: May 23, 2009 - 1:50 AM
edit: i guess i can just take off the whole assembly including all of the lines in once peice
This post has been edited by Projek_01: May 23, 2009 - 1:50 AM
>
on top of the tranny you will see another smaller clip like the pic you posted.
use a 10mm FLARE wrench, undo the fitting, pull the clip, and your good to go.
you will need to fill and bleed the clutch afterwards.
QUOTE (Projek_01 @ May 23, 2009 - 1:38 AM) 
>that seems simple enough, thanks enderswift! i cant believe i didn't try doing that. What is the best way to take off the clutch line to remove the tranny without loosing all of the fluid to the ground? thanks!
edit: i guess i can just take off the whole assembly including all of the lines in once peice
edit: i guess i can just take off the whole assembly including all of the lines in once peice
on top of the tranny you will see another smaller clip like the pic you posted.
use a 10mm FLARE wrench, undo the fitting, pull the clip, and your good to go.
you will need to fill and bleed the clutch afterwards.
Former Team 5SFTE pro member ;)13.6@108MPH, 5SFTE Powered