This is the shaft that is needed for the 3S-GTE swap. This is a complete modified shaft with custom spacers built in. I will post a picture this weekend. Wanted to post this now for anyone looking for this. $50.00 plus shipping. I am located in Southern California. I will meet half way for locals.
FS: MODIFIED CV SHAFT FOR 3S-GTE SWAP - 6G Celicas Forums
hate to boost your thread but quick question, where'd you get the spacers? and how thick are they? thanks
proud =3sgte SWAPPED= '95 Celica ST owner [calling it the GT2 or half-trac]309,000 miles n' ....dead-> ALIVE AGAIN!! ~14,000 miles driven
>
No problrm. It was done at a high performance shop in Corona Calif. Not sure how thick they are. They made up the space that was missing when it was transfered from the Celica from Japan to the Celica that was made for the U.S. The diameter was milled perfect to match exaclly to the diameter of the CV shaft. It's real quality work. It cost me $200.00 to do. Worth every penney.
QUOTE (cjh4l22 @ Feb 3, 2010 - 7:52 PM) 
>hate to boost your thread but quick question, where'd you get the spacers? and how thick are they? thanks
No problrm. It was done at a high performance shop in Corona Calif. Not sure how thick they are. They made up the space that was missing when it was transfered from the Celica from Japan to the Celica that was made for the U.S. The diameter was milled perfect to match exaclly to the diameter of the CV shaft. It's real quality work. It cost me $200.00 to do. Worth every penney.
Sent you PM. I'm ready to buy it from you.
Past -7A-FTE: Will never forget youPresent -3rd Gen3S-GTE: Swap in progressQUOTE (SinisterSinner @ Dec 19, 2009 - 10:52 AM)I dont want to even think of turbos, they blow up way too often...