Do these engines not have specifications? piston to wall clearance, ring end gap, main and rod bearings? i seen the use of a plastigauge which works but is crude. Just looking for clearance spec's, if anyone has them please reply back it would be greatly appreciated.
Cleaning and improving my new found yoter little by little.
Did you also reuse the rod bolts? i read somewhere on here 94-95 you could, but 96+ was tq to yield. Is rod bolts a dealer only part if they have to be replaced, sure seem to be.
Cleaning and improving my new found yoter little by little.
yes all the specs are available in the BGB or techinfo.toyota.com yes i reused the rod bolts. they are TTY but they can be used again. this isnt a high performance engine.
2001 Celica GT-S Turbo1997 Supra TT 6speed1997 Celica 3MZ/1MZ swap1990 Celica All-Trac
Ah i see, appreciate it.
This post has been edited by Takumi-FujiWaraST: May 19, 2013 - 4:31 AM
Cleaning and improving my new found yoter little by little.
