so for everyone who swapped i was curious what sort of exhaust setups you are running as I plan mine. descriptions would be much appreciated as I have several questions.
first. using an aftermarket downpipe, does anyone know if an st185 (all-trac) mid-pipe or b-pipe (goes from downpipe, under axle above under carriage etc..) will fit?? I need that flex section taken care of but I'd prefer not to take it to a shop.
thanks for any advice you might have and info about your current setup.

i don't know too much about em but you'd prob be better off going to an exhaust shop. prob cheaper overall

a full 3inch back here cost like 5-650

which is prob cheaper after shipping and sh*t

lurk ebay, i scored a kakimoto racin exhaust.

i wouldnt put anything but a 3" turbo back setup on a 3s.
the alltrac midpipe wont fit.
custom is your best bet IMO

>

There is a thread somewhere on here that is specifically for custom exhaust setups. Also, if you look at Brent's (SeverX13)thread on his turbo build, there are some pictures on how we set up his downpipe, which was all custom made, and also the rest of his exhaust system. I personally took pictures from Manny's (presure2) thread on his turbo build TO the exhaust shop when I had them do Brent's exhaust. The shop we took Brent's to charged around $300 for a downpipe back setup. HOWEVER, we provided the catalytic converter and also the muffler for them, so that also cut down the costs a little bit.

Not boosted yet, im still sourcing everything for my swap and saving here and there, but from my header back i have a 2.5in custom fit and it was only 200 where i live

This post has been edited by JuMPiiN: Mar 11, 2010 - 12:28 PM