so i'm finishing up my 3s swap and plugging everything in when i realize i forgot where most of these connectors go. so i'm looking for some help and perhaps this will get stickied to help others in the future. thanks.


1 -reverse

ignitor & coil

4 -map sensor

5

6

7

8, 9, 10

11

12

13

14

15 -a/c compressor

16 -A4 Triple Pressure SW 90980-10943

17 -o2 sensor

thanks in advance

This post has been edited by cjh4l22: Mar 29, 2010 - 4:23 PM

it would help to know where they are coming from..a lot of the plugs are similar

i dont have my car in front of me but ill give some of them a try...


#1 I dont have plugged into anything... its from my old harness
#2 looks like it goes into the igniter on the firewall

#10 (the smallest in the picture) im sure clips into the heat temperature sensor on the block
#11 looks like its for the MAF sensor on the intake

#14 i dont even think i have

#15 i thought went into the starter

I can confirm these when i get home later. Keep in mind i have a 2nd gen 3s

This post has been edited by eggman40: Mar 18, 2010 - 11:58 AM

>

2nd gen 3sgte ('91 mr2 t) into '95 st (had P.S., A/C, no abs)

bump really need 12 & 16. thanks.

>


It would help it we could see what location the wire are in. With the harness laid out like it goes the plugs should end up by certain parts and sensors. I just unhooked my harness and all me plugs look similiar. I took pics also . And I got the correct bracket its the small one under the a/ccompressor sending it n the morning

2 & 3 are ignitor and coil