-Jay95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve
why does it say 50 just sitting there?
Breaking Axles...
>
QUOTE (pittfirefighter @ May 17, 2010 - 10:15 AM)
>why does it say 50 just sitting there?
the dial face spins and the needle stays in the same place so you can set it to 0 or whatever you want to if it starts to go out of calibration. That was just what I had it set to when I took the picture, I didn't even notice it was on 50. Here's another picture with the needle in the same place and the gauge face spun around to 0.
-Jay95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve
