man down.
need this, circled in red.
This post has been edited by purplegt4: Aug 26, 2010 - 2:05 PM
need this, circled in red.
This post has been edited by purplegt4: Aug 26, 2010 - 2:05 PM
WTB: 3sgte water pump phillips head screw - 6G Celicas Forums
I'm 50/50 it's the same as a 5S one but it's been a bit since I did a 5S WP.
If so I have one you can have. LMK
If so I have one you can have. LMK
ENGINE: '93 RC 3S-GTE/WRC CT-20b [18-20PSI]PERF: TRD/HKS/ARP/NGK/MSD/ACT/Blitz/STRI/APEX'i/TwosRus/GReddy/Magnaflo/KOYOSUSP: Tein/Bilstein/SusTech/INT: SS-III SEATS/Toyota Hyper SportsEXT: WRC/TRD/404QUOTE (lagos @ Aug 25, 2010 - 10:13 AM)Its a safety feature so that people like you don't end up killing themselves or everyone around them.Slow down Paul Walker.6GC Chat - Go there: [url="http://www.griffgirl.com/forum/chat/index.php[/url]
should've used an impact driver.
>
so I can pretty much just go to the dealership and pick one up. too bad the parts place closes before I get off work.
>
QUOTE (DEATH @ Aug 25, 2010 - 10:11 AM) 
>I'm 50/50 it's the same as a 5S one but it's been a bit since I did a 5S WP.
If so I have one you can have. LMK
If so I have one you can have. LMK
so I can pretty much just go to the dealership and pick one up. too bad the parts place closes before I get off work.
Not 100% sure so check the P/N on each one for confirmation. If the P/N is the same obviously the screw will be also
ENGINE: '93 RC 3S-GTE/WRC CT-20b [18-20PSI]PERF: TRD/HKS/ARP/NGK/MSD/ACT/Blitz/STRI/APEX'i/TwosRus/GReddy/Magnaflo/KOYOSUSP: Tein/Bilstein/SusTech/INT: SS-III SEATS/Toyota Hyper SportsEXT: WRC/TRD/404QUOTE (lagos @ Aug 25, 2010 - 10:13 AM)Its a safety feature so that people like you don't end up killing themselves or everyone around them.Slow down Paul Walker.6GC Chat - Go there: [url="http://www.griffgirl.com/forum/chat/index.php[/url]
I replaced mine with a Hex bolt from autozone, so it'll be easier to remove later, I hate that phillips screw there.
it costed me 1.20
it costed me 1.20
>
k good.
QUOTE (Culpable04 @ Aug 25, 2010 - 3:54 PM)
>I replaced mine with a Hex bolt from autozone, so it'll be easier to remove later, I hate that phillips screw there.
it costed me 1.20
it costed me 1.20
k good.
I think the part number is: 9322016020
its not listed as a screw or a bolt, but its in that same location.
its not listed as a screw or a bolt, but its in that same location.
15PSI - 30MPG - Megasquirt Tuned
fischers hardware ftw. matched it exactly.
Close please.
Close please.