i need help on removin my driver ide cv joint on my 5sfe i dont seem to be able to pull it out of the tranny...is something else holdig it in? plz help me asap

slide hammer with puller attachment.............telling ya it'll knock it out fast. Or just keep on pryin....just be carefuly not to damage the axle seal.

there is a snap ring on the axle, you have to use a pry bar and pry one the axle. give it a small rotation then pry, repeate, it will pop out when it finds its sweet spot

while your replacing the cv go ahead and spend another 10 bucks on a new inner axle seal, and a seal puller, make sure you use the seal puller it will make your life a whole lot easier. and like i figured out its alot easier to replace it the first time than to take it apart and do it all again

thanks to all of yall

hope this helps!

http://www.6gc.net/forums/index.php?showto...2;cv+axle\

I would just get underneath the car, get a smackable large flat head screwdriver and smack that axle out.