I have nearly everything connected to my autronic SM4 that will be powering my engine. My chiltons manual doesn't show my speed sensor wiring. It shows it in the breakaway transmission view, so I know the writers of the manual knew that the sensor existed. They just left it out of the wire diagram. Which means that I can't wire it into the SM4. Does anyone know what the pinout is of the 3 pin speed sensor? Not the one that the book says is by the wheels (my car doesn't have that one), its between both of the halfshafts on the top of the trans. My trans is a manual 95 stock 5sfe trans.
This post has been edited by match220: Jun 18, 2011 - 7:25 AM
This post has been edited by match220: Jun 18, 2011 - 7:25 AM
-Jay95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve