(almost) EVERYTHING MUST GO

It's a red GT Coupe with almost 194k miles on it. No sunroof, 6-speaker system for those interested in headliner and door panels.

Everything that I can take off myself and isn't too big ships from New Jersey via [your choice]. If it's big/heavy (e.g. the entire interior) or I can't remove it fairly easy (e.g. rear motor mount), I'd rather you pull it yourself. Make an offer for whatever you want. For parts that come in 2s (or 4s, or whatever), I'd rather sell them as a set.

Recently changed (within the past year):
Front, Rear, Tranny Mounts (Anchor brand, last month)
Sleeved the pipe that runs from the flex pipe to the cat. There was a flange there, now there's a sleeve because the stress that the bad mounts caused broke the flange (last month)
Air Intake - Replaced with K&N and black metal short ram. Practically new (less than 5,000 miles on those)
Timing Belt, Water Pump (new, not rebuilt), Thermostat, Water Pump Gasket (this spring, less than 15k miles ago)
Spark Plugs (NGK Iridium), Spark Plug Wires (NGK OE), Distributor Rotor, Distributor Cap
Belts (Power Steering, Alternator, and whatever the third one is)
Valve Cover Gasket, Tube Seals
Struts (KYB), Strut Mounts, boots, and bump stops
Left Axle/CV/whatever it's called

Also changed, but a little over a year ago: Flex Pipe

Things you don't want because they're in crap condition:
Left axle
The power steering system as a whole - if you want certain parts, I'll inspect them and tell you the condition, but something somewhere is leaking so you definitely don't want the whole system
Trunk lift struts
Left low-beam
Cabin air filter
Certain parts of the interior - ask for specifics and I'll send you pics of them
Head unit (aftermarket, CD player has problems)
Gauges (Reverse Glow, but with LED issues)
Driver's side window regulator/motor
Front right bottom speaker from 6-speaker system

Non-Standard Parts:
TRD Shift Knob
K&N filter and short ram intake (see "recently changed")
Wheels are 17" Scion tC rims (not the new ones). Pretty bad curb rash on the rims of all 4; BARE RIMS, I had to move the tires to the new car
Tanabe Lowering Springs. 2.2" in the front, 1.5" in the back.
Not sure if the clutch is OEM. I just know it was changed before I got it (around 80-90k?).

SOLD (or promised to people):
Air bags + controller
Alternator
Climate control unit (the box with the knobs and the two cables)
Valve cover + nuts
Window trim

Anything else, make an offer!

This post has been edited by Rider: Jan 15, 2012 - 6:20 AM

Window Trim (Both driver/passenger front and rear)
?

What color is the car? I'm looking to buy the hood from you.

Any pics of the door panels?

i need three female plugs with about 6 inches of wire still hooked to them. The far left one is the oil pressure switch female plug the other one on far right I have no clue what its called but you can see where it is in the photo. If you can get these two plus the one in the middle of them, they all come out of the same wire loom, for me that would be great.

NOTE TO EVERYONE: I'll be posting daily updates, but the car is about 15 miles away so I can only check items every few days.

>

I have to check the condition, but I think all window trim is still good. $10+shipping?

>

Red. Maaco paint job from a couple years ago though, so it's already dull. I think it's in good condition, but I gotta go and check. I'll post up pics Friday. Assuming it's not bent or anything, $75+shipping?

>

I'll have pics up for door panels as well Friday, with details of any issues I find.

>

I think I have the first two in good condition, but the wire broke at the top of the third? Again, gotta go and check. Pics will be up Friday.

TL;DR? I'M RESPONDING TO SPECIFIC POSTS. PICS WILL BE UP FRIDAY FOR EVERYTHING THAT WAS REQUESTED

are the front seats in good condition i live in new york so i will come pick them up how much

how much for CC unit and MAP light?

>

Driver's seat is pretty good, but the plastic part (where the seat back adjustment is) is loose. Passenger's seat has a tear right in the middle, probably 8 inches long and pretty deep.

Are you willing to take them out yourself? Who knows, maybe you'll find something else you like*

*Just kidding, I just don't want to have to take them out myself.

QUICK NOTE:
Several people have already asked me about shocks/struts and springs, so there's a sort of waiting list for each already. If you've PMed me, wait for a reply; otherwise, assume they're already sold unless I post otherwise.

This post has been edited by Rider: Oct 20, 2011 - 11:22 PM

Do you have the center console ashtray?

stock muffler?

$10 shipping, as long as its in good condition let me know what total is to 76106

>
Yes. It smells like smoke.

>
Yup. Make an offer.

>
PMed.

>
No pic necessary. No dents. PM me if you're still interested.

>

They're worse than I thought. I'll PM you pics tomorrow evening.

To str8thugginit4ya and foxcraze: Sorry, no pics today. I'll PM you guys pics tomorrow (Saturday) evening.

This post has been edited by Rider: Oct 22, 2011 - 3:26 AM

pm!

got pics of the front seats???

do you have the gt rear disc brake assembly? and how much? i only need the hubs and e break cable

dont need the rotors/disc or calipers

How much for the driver's side tail light shipped to 83843? Thanks!

I need the center bezel..(the one around the head unit/ac unit). I'm also interested in the engine mounts....I need the front/rear/driver side if available.

Thanks

^ ^ ^ I'll have specific replies for you guys (LimitedGT4, rkelly_83543, jiggy2dmax) tomorrow afternoon/evening, sorry... I've been busy looking for another car pretty much 24 hours a day. Basically, everything you guys want is available, but the E-brake cable may be screwed up. The front seat pics for advancetoyota and kingcarlito4991 will be up tomorrow as well.

Any chance you still have the two knobs from the heater controls?

I'll buy both from you if so.

Thanks

I will need all the cruise control sistem such as actuator, cables etc.. let me know if you sell it.
Thanks

how old are the lowering springs and how much would you sell em for? thanks

>

Someone is buying the entire CC unit. Sorry.

>

Yes, but I'll have to figure out how to take it out. And I'm working on removing other parts right now, so it'll be a while.

>

About 3-4 people already messaged me about them, so I'm gonna say they're practically sold already. I'll put you on the "waiting list," but I'd search for other sources in the meantime if I were you.

OMG PICS!!

Front seat pics were sent to the two that asked for them.

Driver's Door Panel:

No tears, some scuffing.

The glue is not holding the leather too well at the top of the soft part, so it comes out pretty often. Easy fix: put some superglue in there.


Passenger's Door Panel:

Obvious tear there, plus a small cigarette burn on the flat part that continues from the handle (you can't see it), plus a cut toward the top, next to the window (look right above the circular tear, right by the grass; you should be able to see it when you zoom in). I DO have the hinge insert, it's just not shown in the picture. Some scuffing, less than driver's side.

DOOR PANEL NOTE: One screw and one screw cap are missing.

Pic of the requested plugs:

Obviously the wire on the third one is cut/torn.

Useless pic of the hood to prove there are no dents:


This post has been edited by Rider: Oct 24, 2011 - 10:58 PM

>
PM me with an offer.

>
PM me with offers for everything. Mounts are Anchor brand, practically new.

>
Let me get back to you, I'm waiting for a response from someone else.

This post has been edited by Rider: Oct 24, 2011 - 11:53 PM

"i need three female plugs with about 6 inches of wire still hooked to them. The far left one is the oil pressure switch female plug the other one on far right I have no clue what its called but you can see where it is in the photo. If you can get these two plus the one in the middle of them, they all come out of the same wire loom, for me that would be great."


Hey man i will gladly take those two plugs off of you but there is one plug from my picture you didnt show its to the left of those three mounted to the block closer to the header. If you look at my pic again you will see what i mean. If that third one is good as well i will take all three with about 6-8 inches of wire coming from each. How much do i owe you?

Pic of the requested plugs:

Obviously the wire on the third one is cut/torn.

I could use the air bags & air bag controller if they are still available?

>
How do I go about removing those??

The Driver's side air bag is easy - just unbolt from the steering wheel. The Passenger air bag, you have to unbolt the dash to get to its fasteners. I believe the controller is inside the center console (but will verify tonight). If you need it, I can write up more specific instructions.

>
I took the center cubby/armrest off a couple days ago and it's under there, but what do I do, just unplug it? I don't want the airbags to go off because I did something stupid. Any special requests I'd have to make when shipping because it could go off or something?

Also, you should probably know they haven't been tested during the life of the car. I know the usual test interval is every 10 years.